kingsley-bate TR-36 User manual

KINGSLEY –BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE TR - 36/42/50/60
LEGS TABLE TOP TABLE BASE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
* NOTE
A TENON
B MORTISE HOLE
STEP-II
Place the TABLE TOP face down and carefully insert the LEG tenons into the respective
mortise holes of the TABLE TOP. Tenons of the LEGS will be marked with a number or
a letter to correspond with the respective mortise holes of the TABLE BASE. Insert all
four LEG tenons into the respective mortise holes of the TABLE TOP.

STEP-III
Carefully take the TABLE BASE and insert the LEG tenons into the respective mortise
holes of the TABLE BASE. Make sure that the numbered or lettered tenons match the
mortise holes. Using a rubber mallet or a regular hammer with a wood block between the
hammer and the wood, drive the tenons and mortise holes together until all joints fit
snugly together.
NOTE: Do not force
dowels. Any excess can
be easily sanded away.
STEP-IV
Drive the wooden dowels through the tenons of the LEGS. Two dowels should be driven
through each tenon for all tables. Drive the dowels using direct sharp blows with a
hammer. Take care not to mar the wood. You may want to sand lightly to smooth out any
rough edges.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE
DEALER NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU
FOR CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE IF THESE
INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone. [phone], Fax. [phone]