kingsley-bate Nantucket NT15 User manual

Kingsley-Bate
NT15 Nantucket Dining Chair
Assembly Instructions

KINGSLEY – BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE NT 15/25
BACK SEAT
* NOTE
A TENON
B MORTISE HOLE
RIGHT END FRAME LEFT END FRAME
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of furniture please match joints with the correspondi ng letter or
numbers.
STEP-II
Fit the BACK LEG STRETCHE R, BACK STRETCHER, an d
SEAT into the RIGHT END FRAM E mortise holes. If necessary ,
gently rock the BACK LEG S TTTRETCHER while pushing the
tenon into the mortise hole until the jo int fits snugly together. Make
sure that the numbered tenons corre spond with the num bered
mortise holes.
3STEP-III
4Carefully fit the
remaining LEFT END
FRAME mortise holes
over all exposed
tenons. Using a rubber
mallet or a regular
hammer with the sanding block between the ha mmer and the wood, gently dri ve all the
mortise holes onto the tenons until all joints fi t snugly together. Slide BACK FRAME into
position using the exposed dowels in the SEAT FRAME as a guide.
STEP-IV
Using a proper screw driver, insert and secure all knock down bolts
as shown on the assembly diagram.

STEP-V
Carefully hammer dowels into LEFT an d RIGHT END FRAMES. Us e the sanding block
between the hammer and the dowels to prevent marring of the wood.
NOTE : 1” DOWEL USED FOR PLUGGING END FRAMES
STEP-VI
Carefully drive the brass pins into the LEF T and RIGHT END
FRAMES. Once flush with t he wood, use the 1” plugs to cover the
brass pins. Again, use the sanding block between the hammer and the
wood to prevent any marring of the wood.
NOTE: DO NOT FORCE THE DOWELS.
ANY EXCESS CAN EASILY BE
SANDED AWAY.
0STEP-VII
Insert screws into pre-dr illed holes of the SEAT
FRAME and the BACK STRETCHER as shown on
the assembly diagram. Do not hammer in the screws, drive them in with a proper screw
driver.
STEP-VIII
Carefully hammer the plugs into the BACK STRETCHER
to cover the screw holes. Again, if t he plugs are not
completely flush, just sand away the excess with the
sanding block provided.
1NOTE: ½” DOWEL USED FOR COVERING SCREW
2 HOLE IN BACK STRETCHER.
IF YOU HAVE ANY QUESTION REGARDING ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT A KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone. [phone], Fax. [phone]