kingsley-bate PV-24 User manual

ASSEMBLY INSTRUCTIONS FOR THE PV-24/42
ANGLE SUPPORTS TABLE TOP TABLE BASE
* NOTE
A TENON
B MORTISE HOLE
HARDWARE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to
avoid marring the wood.
NOTE: During assembly of the furniture please match all joints
with the corresponding letters or numbers stamped on the furniture.
STEP-II
Flip the TABLE BASE upside
down and with the help of
another person carefully install
the ANGLE SUPPORTS and
the BOTTOM BASE
SUPPORT as shown in the
assembly pictures (use of a rubber mallet may be necessary to drive all joints together).
NOTE: ANGLE SUPPORTS, TABLE BASE and BOTTOM BASE SUPPORT are all
marked with letter and/or numbers for accurate assembly. Once all joints fit snugly
together secure the BOTTOM BASE SUPPORT with the knock down bolts and washers
provided. NOTE: Slide the split washer on first followed by the flat washer onto the
bolt).

STEP-III
Flip BASE ASSEMBLY right side up
and insert screws into respective pre-
drilled holes at the ANGLE SUPPORT
as shown in the assembly photograph.
Do not hammer in the screws, but drive
them in with a proper screw driver. Hammer plug dowels into place as shown in assembly
photographs. Drive the wooden dowels through the tenons of the BOTTOM BASE
SUPPORT and ANGLE SUPPORT; to avoid marring the wood we suggest you use a wood
block between the hammer head and the dowel head for the last few blows.
STEP-IV
Assemble TOP BASE SUPPORT
to the BASE ASSEMBLY with the
knock down bolts and washers
provide (see STEP-II). NOTE:
Please notice stamped letters
and/or numbers on your TABLE TOP and TOP BASE SUPPORT so they match and
line up properly.
STEP-V
Lay TABLE TOP upside down on a
clean, flat, smooth surface. Flip
BASE ASSEMBLY onto TABLE
TOP and matching the markings
secure with hardware and tool
provided (again, slide the split washer on first followed by the flat washer).
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT THE KINGSLEY BATE DEALER
NEAREST TO YOU OR KINGSLEY BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]