kingsley-bate PV-73 User manual

KINGSLEY BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE PV-73/96
TABLE TOP LEG STRETCHER
TABLE BASES HARDWARE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture. ASSEMBLY OF THIS ITEM IS A TWO
PERSON PROCEDURE.
STEP-II
Set LEG STRETCHER upside down as shown in photograph and slide corresponding
TABLE BASE into position gently. Slide a split washer followed by a flat washer over 1 of
the Knock Down Bolts provided and secure with wrench provided. NOTE: Take care not
to over-tighten KD Bolts and DO NOT use power tool. Use of power tool could result in
damage to threaded inserts. Repeat procedure with opposite TABLE BASE.

STEP-III
Place the TABLE TOP face down on a clean, soft surface and carefully fit the completed
TABLE BASE ASSEMBLY onto the TABLE TOP as shown in photographs (TABLE TOP
and TABLE BASE ASSEMBLY ARE STAMPED FOR EASY LINE UP). Again, slide the
split washers, followed by the flat washers onto the Knock Down Bolts provided and lightly
tighten with wrench key provided. Once all bolts have caught thread you can tighten down
all the way.
NOTE: DO NOT ROLL TABLE OVER TO UPRIGHT. TABLE SHOULD BE
LIFTED, ROTATED AND THEN SET DOWN.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
* KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]