kingsley-bate Chelsea CO15 User manual

Kingsley-Bate
CO15 Chelsea Dining Armchair
Assembly Instructions

KINGSLEY–BATE
Fine Garden Furniture
0ASSEMBLY INSTRUCTIONS FOR THE CO-15
RIGHT END FRAME BACK SEAT LEFT END FRAME
* NOTE:
5A TENON
6B MORTISE HOLE
1STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding letters
or numbers stamped on the furniture.
2STEP-II
Fit the BACK and SEAT tenons into t he END FRAME
mortise holes using the stamped num bers or letters as
guides. If necessary, gently rock the BACK and SEAT
while pushing the tenons into the m ortise holes until all
joints fit snugly together.
3STEP-III
Fit the remaining END FRAME m ortise
holes over and onto all exposed tenons
and using a rubber ma llet gently tap the
END FRAME evenly until all joints fit
snugly together. Carefully hammer
dowels into the pre-drilled holes of the assembly, details are shown in the photographs. All
dowels and dowel holes are prope rly marked with stickers. NOTE: DO NOT FORCE THE
DOWELS; ANY EXCESS CAN EASILY BE SANDED AWAY. IF THE DOWELS ARE
NOT FLUSH DO NOT CONTINUE TO DRIVE THE DOWELS, YOU MIGHT
DAMAGE THE ITEM.

4STEP-IV
Place the assembled chair upside down on top of a table so chair sits level as seen in the above
photographs. Place the small brackets into place and insert the screws using a proper screw
driver. We strongly suggest you do not use a power screwdriver, the torque could easily drive
the screws too far into the bracket and damage the END FRAME.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]