kingsley-bate TR-100 User manual

KINGSLEY-BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE TR-100
TABLE TOP
* NOTE
A TENON
B MORTISE HOLE
LEGS
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match the tenons and mortise holes with the
corresponding letters or numbers stamped on the component parts.
STEP-II
Fit tenons of the LEGS into the respective
mortise holes of the BASES. If necessary,
gently rock the parts while pushing the tenons
into the mortise holes until joints fit snugly.
Dowel the joints as shown in
the photographs.
STEP-III
Fit the LEG STRETCHERS into the LEGS and
dowel the joints. Again, match the numbers of
the tenons with the corresponding mortise
holes. Dowel the joints as shown in the
photographs.

STEP-IV:
Fit this newly assembled table base onto the TABLE TOP matching the letters stamped on
the legs to the letters shown on the TABLE TOP. Each joint requires two bolts, solid
washers, split washers and nuts with the split washer placed between the solid washer and
nut. With a flat head screw driver and the tool provided, securely tighten each bolt and nut.
NOTE: To upright the table you will need two people. Table should be lifted, turned over
and placed down. Attempting to roll table over to the upright position may cause damage to
the leg/base assembly.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]