kingsley-bate CO-15 User manual

KINGSLEY~BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE CO-15
RIGHT END FRAME BACK SEAT LEFT END FRAME
* NOTE:
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft
surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Fit the BACK and SEAT tenons into the END FRAME
mortise holes using the stamped numbers or letters as
guides. If necessary, gently rock the BACK and SEAT
while pushing the tenons into the mortise holes until all
joints fit snugly together.
STEP-III
Fit the remaining END FRAME mortise
holes over and onto all exposed tenons
and using a rubber mallet gently tap the
END FRAME evenly until all joints fit
snugly together. Carefully hammer
dowels into the pre-drilled holes of the assembly, details are shown in the photographs. All
dowels and dowel holes are properly marked with stickers. NOTE: DO NOT FORCE THE
DOWELS; ANY EXCESS CAN EASILY BE SANDED AWAY. IF THE DOWELS
ARE NOT FLUSH DO NOT CONTINUE TO DRIVE THE DOWELS, YOU MIGHT
DAMAGE THE ITEM.

STEP-IV
Place the assembled chair upside down on top of a table so chair sits level as seen in the
above photographs. Place the small brackets into place and insert the KD bolt in the center
first using the Allen key provided. Insert the screws using a proper screw driver. We strongly
suggest you do not use a power screwdriver; the torque could easily drive the screws too far
into the bracket and damage the END FRAME.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
*KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]