kingsley-bate SC-25 User manual

KINGSLEY~BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE SC-25
LIFT OUT TRAY DRAWERS TOP FRAME BOTTOM FRAME
DRAWER FRAME END FRAME WITH WING END FRAME W/O WING
* NOTE
A TENON
B MORTISE HOLE
WHEELS
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.
STEP-II
Find the END FRAME W/O WING (should be the
one with numbers stamped on it). Lay this END
FRAME down first. Matching the numbers on the
END FRAME with those on the TOP FRAME,
BOTTOM FRAME, HANDLE BARS and
DRAWER FRAME, BOTTLE RACK carefully line up all parts. Using a rubber mallet,
evenly drive all the tenons into the mortise holes as shown in the assembly photos.

STEP-III
Carefully place & align the END FRAME WITH WING onto the assembled TOP FRAME,
BOTTOM FRAME, HANDLE BARS, BOTTLE RACK and DRAWER FRAME. The TOP
FRAME has an extension arm with a leather pull attached to it. Please make sure that the
leather pull is aligned properly with the routed hole in the END FRAME WITH WING. If the
leather strap is folded over you will not be able to pull the extension arm out. Carefully drive
the wooden dowels as shown in the diagram.
*NOTE: Before inserting the dowels in the HANDLE BARS you will have to spin them
around until you can see the holes line up on both sides. PLEASE MAKE SURE THAT
BOTH HOLES LINE UP. NOT DOING SO WILL CAUSE DAMAGE TO THE CART.
Drive the wooden dowels into their corresponding holes before flipping the cart around.
DO NOT FORCE THE DOWELS FURTHER THAN THEY WILL GO. ANY EXCESS
CAN EASILY BE SANDED AWAY.
STEP-IV
Gently flip the TROLLY over so that it is upside
down. Drive the small dowels into the middle of
the TOP FRAME, and under the HANDLE
BARS and END FRAMES.
STEP-V
Slide the wheel onto the bolt and
then slide the large washer onto
the bolt. Now, insert the bolt
through the END FRAME leg
and slide the second smaller
washer onto the bolt. Repeat with
other wheel and tighten the two nuts. Do not tighten too hard or the wheels will not turn.

STEP-VI
Slide the drawers into place as shown in the diagram.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY-BATE FURNITURE, PLEASE CONTACT THE KINGSLEY-BATE DEALER
NEAREST TO YOU OR KINGSLEY-BATE DIRECTLY. WE THANK YOU FOR
CHOOSING OUR FURNITURE.
* KINGSLEY-BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY
7200 Gateway Court, Manassas, Virginia 20109
Phone. [phone], Fax. [phone]