kingsley-bate PV-50 User manual

KINGSLEY BATE
Fine Garden Furniture
ASSEMBLY INSTRUCTIONS FOR THE PV-50/59
ANGLE BRACKETS TABLE TOP TABLE BASE
HARDWARE
* NOTE
A TENON
B MORTISE HOLE
STEP-I
Unpack, inspect and lay the parts on a clean, flat, soft surface to avoid marring the wood.
NOTE: During assembly of the furniture please match all joints with the corresponding
letters or numbers stamped on the furniture.

STEP-II
Upright the TABLE
BASE and fit the TOP
CROSS BAR along
with 2 ANGLE
BRACKETS into
place as shown in
above photographs (NOTE: This is a two person procedure). Drive the tenons and mortise
holes together until all joints fit snugly together.
STEP-III
Drive the wooden
dowels through the
tenons of the TOP
CROSS BAR. It is
recommended that
you use the wood
sanding block between the hammerhead and the dowel head for the last few blows to avoid
marring the wood. NOTE: Do not force dowels. Any excess can be easily sanded away
Slide the split washer, followed by the flat washer onto the Knock Down Bolts provided and
tighten with wrench key provided as seen in photographs.
STEP-IV
Flip table base upside down and repeat STEP-II and STEP-III.

STEP-V
Flip BASE ASSEMBLY right side up and insert
screws into respective pre-drilled holes at the
ANGLE BRACKETS as shown in the assembly
photograph.Do not hammer in the screws, but drive
them in with a proper screw driver. Hammer plug
dowels into place as shown in assembly
photographs. Drive the wooden dowels through the tenons of the BASE CROSS BAR and
ANGLE BRACKETS; to avoid marring the wood we suggest you use a wood block between
the hammer head and the dowel head for the last few blows.
STEP-VI
Place the TABLE TOP
face down on a clean, soft
surface and carefully fit the
completed TABLE BASE
ASSEMBLY onto the
TABLE TOP as shown in
photographs (TABLE TOP
and TABLE BASE ASSEMBLY ARE STAMPED FOR EASY LINE UP). Again, slide the
split washers, followed by the flat washers onto the Knock Down Bolts provided and tighten
with wrench key provided.
NOTE: DO NOT ROLL OVER TABLE TO UPRIGHT. TABLE SHOULD BE LIFTED,
ROTATED AND THEN SET DOWN.
IF YOU HAVE ANY QUESTIONS REGARDING THE ASSEMBLY OF YOUR
KINGSLEY BATE FURNITURE, PLEASE CONTACT KINGSLEY BATE CUSTOMER
SERVICE AT 703-361-7000. WE THANK YOU FOR CHOOSING OUR FURNITURE.
*KINGSLEY BATE WILL NOT TAKE RESPONSIBILITY FOR DAMAGE
IF THESE INSTRUCTIONS ARE NOT FOLLOWED PROPERLY.
7200 Gateway Court, Manassas, Virginia 20109
Phone: [phone], Fax: [phone]