©2017 Kohler Co.
1060273-X2-C
ASIAN EMERGING MARKETS
Asia Customer Service Centre, Kohler Asia Pacific Limited Tel: +(86) 21 2606 2572
KOHLER (THAILAND) PUBLIC COMPANY LIMITED
บริษัท โคหเลอร (ประเทศไทย) จํากัด (มหาชน) : ลูกคาสัมพันธ/Call Center 0 2204 6222
For best results, keep the following in mind when caring for your
product:
• Carefully read the cleaner product label to ensure the cleaner is safe
for use on the material.
• Always test your cleaning solution on an inconspicuous area before
applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately
after cleaner application. Rinse and dry any overspray that lands on
nearby surfaces.
• Do not allow cleaners to sit or soak on the surface.
• Use a soft, dampened sponge or cloth. Never use an abrasive
material such as a brush or scouring pad to clean surfaces.
• Be careful not to leave staining materials in contact with the surface
for extended periods of time.
• The ideal cleaning technique is to rinse thoroughly and blot dry any
water from the surface after each use.
WARNING: Risk of property or product damage. Do not
use in-tank cleaners in your toilet. Products containing
chlorine (calcium hypochlorite) can seriously damage fiings
in the tank. This damage can cause leakage and property
damage.
Troubleshooting Care and Cleaning
การดูแลรักษาและการทําความสะอาด
Symptoms Recommended Action
1. Poor flush. A. Adjust the tank water level to match the
waterline.
B. Fully open the water supply shut-off valve.
C. Clear obstructions from the trapway, jet, or bowl
rim holes.
D. Clear obstructions from the waste line.
2. No flush. A. Mask sure the push buon rods are in place.
Adjust as needed
3.
The fill valve
A. Adjust push buon rods for proper slack so the
turns on/off
flush valve seal inn’t held off the flush valve.
by itself B. Clean or replace the flapper if it is worn, dirty, or
without the misaligned with the opening.
toilet being
C. Clean the area around the opening to allow
flushed, or it
the flapper to seal.
runs, allowing
D
. Adjust the tank water level if it is too high.
water to enter
E. Replace the fill valve if the valve float sinks.
the tank.
F. Adjust the tank water level if it is too high.
4. Tank takes A. Fully open the water supply shut-off valve.
excessive time
B. Check the flexible supply line (if applicable) for
to fill. a kink. Remove the kink.
C. Clean the valve inlet, valve head, or supply line.
Flush the lines.
5. There is A. Partially close the water supply shut-off valve if
excessive the waterpressure to the toilet is too high.
noise when Check the toilet performance following any such
the tank adjustment.
is filling. B. Remove dirt or obstructions from the valve head.
Flush the lines.
ปญหาที่พบ วิธีการแกไข
1.
2.
ขอแนะนําการแกไขปญหาเบื้องตน
•
•
•
•
•
•
•
ขอควรระวัง ความเสี่ยงซึ่งอาจกอใหเกิดความเสียหายกับที่พัก
อาศัยและสุขภัณฑ
