Kuppersberg T 939 Installation and maintenance instructions

TECHNICAL PASSPORT
T 939, T 969, V 939, V 63 9, Т 669
WALL COOKER HOODS

2
TECHNICAL PASSPORT ENGLISH
Wall cooker hood
1. APPEAL TO THE CUSTOMER.......................................................................................... 3
2. IMPORTANT SAFETY INSTRUCTIONS...................................................................... 3
3. MAINTENANCE AND INSTALLATION MANUAL.................................................. 5
3.1. TECHNICAL CHARACTERISTICS AND DRAWINGS .................................. 5
4. MAINTENANCE AND CLEANING.................................................................................. 9
5. TROUBLESHOOTING.......................................................................................................... 9
5.1. PROBLEM SOLVING.................................................................................................. 9
CONTENTS

3
ENGLISH TECHNICAL PASSPORT
Wall cooker hood
1. APPEAL TO THE CUSTOMER
Congratulations on your choice. We
are sure that this modern, functional
and practical appliance, made with top
quality materials, will fully satisfy your
needs.
Please read every section of this
INSTRUCTIONS MANUAL before using
your kitchen hood for the fi rst time, to
ensure maximum performance from
the appliance and to avoid breakdowns,
which may be caused by incorrect use,
as well as to allow any minor problems
to be solved.
To obtain optimum performance,
the external conduct must not be more
than FOUR METRES long, have no more
than two 90° angles and its diameter
must be at least 120.
2. IMPORTANT SAFETY
INSTRUCTIONS
ÂPlease be aware of current local
regulations with reference to domestic
electrical fi ttings and gas eduction.
ÂVerify that the tension and
frequency of the network match those
indicated on the label located inside
the kitchen hood.
ÂIf the supply cable is damaged it
should be replaced by the manufacturer,
the after-sales service or a suitably
qualifi ed person in order to avoid
hazard.qualifi ed person in order to
avoid hazard.
ÂIn case your cooker hood is not
provided with a plug for the mains
connection or is not accessible in
normal conditions it is necessary to
install a disconnection switch to the
house installation, according to the
local standards for installations.
ÂMake sure a good ground
connection (this does not apply to class
II appliances, indicated accordingly on
the rate plate with )
ÂOnce the kitchen hood has been
installed, ensure that the mains cable to
the network is not in contact with sharp
metal edges.
ÂThe fumes should not be
extracted through pipes that are used
to evacuate the fumes of gas (or another
fuel) operated devices.
ÂIf the extractor fan is going to be
used simultaneously with equipment
powered by a non-electric energy
source, e.g.: gas cookers, then the room
must have suffi cient ventilation.
ÂExcessive fat accumulation in
the kitchen hood and metal fi lters is a
fi re risk and may also cause dripping,
therefore the inside of the kitchen hood
and the metal fi lters must be cleaned at
least once a month.
ÂThe lower part of the kitchen
hood must be fi tted at least 65cm
over gas or mixed hobs. FOLLOW THE
HOBS. MANUFACTURER’S MINIMUM
RECOMMENDATIONS. This distance
can be reduced if this is indicated by
the manufacturer in the cooker hood
instruction manual.
ÂNever leave gas hobs lit if
not covered by a container. The fat

4
TECHNICAL PASSPORT ENGLISH
Wall cooker hood
accumulated in the fi lters may drip
or catch fi re when the temperature
increases.
ÂAvoid cooking under the kitchen
hood if the metal fi lters are not fi tted,
e.g.: while they are being cleaned in the
dishwasher.
ÂYou must not produce fl ames
under the kitchen hood.
ÂDisconnect the appliance before
any interior manipulation, e.g. during
cleaning or maintenance.
ÂWe recommend the use of gloves
and to be extremely careful when
cleaning the kitchen hood’s interior.
ÂYour kitchen hood is designed
for domestic use and only for extraction
and purifi cation of fumes produced
during food preparation. It will be your
responsibility if it is used for other
purposes, which may be dangerous.
The manufacturer cannot accept
responsibility for damage caused by
improper use of the appliance.
ÂFor repairs please contact the
manufacturer’s nearest Technical
Assistance Service, and always use
genuine spare parts. Repairs or
modifi cations carried out by unqualifi ed
personnel can cause malfunctions or
may damage the appliance, putting your
safety in danger.
ÂThis appliance is marked
according to the European directive
2002/96/EC on “Waste Electrical and
Electronic Equipment” (WEEE). This
guidelineistheframeofaEuropean-wide
validity of return and recycling on Waste
Electrical and Electronic Equipment,
.
ÂThis device is not meant to be
used by persons (including children)
whose physical, sensory or mental
capacities are reduced, or who lack
experience/ knowledge, except if
they have supervision or received
instructions for using the device by the
person responsible for his/her safety.
Keep children away from the device and
never let them play with it.
Instructions for use
You can activate or deactivate the
cooker hood by operating the functions
shown in the diagram.
Switch on the extractor fan a few
minutes before you start to cook in order
to ensure that a steady air fl ow has been
established before fumes appear.
Allow the extractor fan to run for
several minutes after you have fi nished
cooking (between 3 to 5 minutes) in
order to expel all the grease from the
outlet duct. This prevents the return of
grease, smoke and smells.

5
ENGLISH TECHNICAL PASSPORT
Wall cooker hood
3. MAINTENANCE AND INSTALLATION MANUAL.
3.1. TECHNICAL CHARACTERISTICS AND DRAWINGS
T 939 T 969
V 939/ V 639 T 669

6
TECHNICAL PASSPORT ENGLISH
Wall cooker hood

7
ENGLISH TECHNICAL PASSPORT
Wall cooker hood
1
2

8
TECHNICAL PASSPORT ENGLISH
Wall cooker hood
3
4

9
ENGLISH TECHNICAL PASSPORT
Wall cooker hood
4. MAINTENANCE
AND CLEANING
During cleaning and maintenance
work, make sure the safety instructions
are complied with.
Cleaning the hood body
ÂIf your kitchen hood is made of
stainless steel, use proprietary cleaners
mentioned in the product instructions.
ÂIf your kitchen hood is painted,
use lukewarm water and a neutral soap.
ÂNever use metallic scourers, nor
abrasive or corrosive products.
ÂDry the kitchen hood using a
cloth that does not produce fi bres.
ÂDo not use vapour cleaners.
Cleaning the metal fi lters
ÂTo remove the fi lters from their
fi ttings, press lightly on the locks and
then pull them off.
ÂThe metal fi lters can be cleaned
by soaking them in hot water with
neutral detergent until the fat dissolves
and then rinsing them under the tap or
using special anti-grease products.They
can also be washed in a dishwasher. In
this case, it is advisable to stack them
vertically to avoid food residues to stick
to them.
ÂCleaning in a dishwasher may
damage the metallic surface (blackening
it), although this will not affect its fat
retention capacity.
ÂOnce clean, leave them to dry off
and then fi t them onto the kitchen hood.
Lamps
For changing the light bulbs please
contact the manufacturer’s nearest
Technical Service.
5. TROUBLESHOOTING
5.1. Problem solving
Proceed with the following checks
before calling the Technical Service:
Problem Possible
cause Solution
The
kitchen
hood does
not work.
The mains
cable is not
connected to
the network.
There is no
current in the
netw ork.
Connect the
mains cable to the
network.
Provide current to
the network.
The
kitchen
hood does
not extract
suffi ciently
or vibrates.
Filters are
saturated
with fat.
Obstruction
in the air
outlet.
Change or clean
the active charcoal
and/or metal
fi lters.
Remove the
obstruction.
Active charcoal fi lters (Optional)
When exterior gas extraction is not
possible, then the kitchen hood may
be set to purify the air by recycling it
through active charcoal fi lters.
The active charcoal fi lters have
an active life of between three to six
months, depending on the individual
conditions of use. These fi lters cannot
be washed nor regenerated. They must
be replaced once their useful life comes
to an end.
The manufacturer reserves the right
to make changes and corrections to its
products as it deems necessary, without
altering their basic characteristics.