Lee & Plumpton SmartTop Series User manual

No. 085 A/0944 Revision B 16/10/2019 1
www.leeandplumpton.co.uk
ASSEMBLY INSTRUCTIONS
RANGE SmartTop
REF: Single Desk
Read this leaet before
assembly
2 People
Required
COMPONENT PARTS
TOOLS REQUIRED BEFORE YOU BEGIN...
• Check you have all the tools and components required
• Keep children and animals away from small parts
• Ensure you have adequate space
• Assemble product on a at, clean surface
• Apply manual handling guidelines when building this item
• Pozi head screwdriver
Minimum 200mm long
• T30 Allen Key (Supplied)
• 5mm Allen Key
IMPORTANT:
• Cables for the monitor and keyboard must not impede, or interfere with, the gas assisted strut as this could
damage the mechanism. Please ensure you use the cable clamps provided.
Please check the below details before attaching computer hardware:
• The maximum monitor size is 19 inches (486.2mm).
• Keyboard maximum dimensions 475mm wide x 40mm depth
• The overall weight of the complete item is 35kgs, apply manual handling guidelines.
• Only use component xings supplied with this item.
• When closing monitor lid place hand in centre of the top to prevent trapping ngers or thumb and press
down until lid contacts latch.
Item A
60mm Chipfast Bolt NP
F/0486
Qty 4
Item B
Minix Bolt M6
F/0433
Qty 4
Item C
Wood Dowel
F/0431
Qty 2
Item D
Minix Alloy Cams 18mm
F/0434
Qty 4
Item E
Adjustable Foot Black
F/0606
Qty 4
Item F
Minix Cover Cap
F/0545
Qty 4
Item G
Hole Plugs Grey 5mm
A/0585
Qty 4

No. 085 A/0944 Revision B 16/10/2019 2
STEP 1
ASSEMBLY INSTRUCTIONS
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
STEP 7
STEP 8
STEP 9
CARE AND MAINTENANCE
Place top on a at even surface.
Place part (C) in appropriate holes
in modesty panel.
Push part (D) (with the arrows facing
out) into the holes of the modesty.
(Ensuring the holes are free from
debris)
Take the modesty and lower into the
top. Ensuring the holes are lined up.
Screw part (B) into the holes of
the upright on the cantilever legs
and attach part (E) to bottom of
cantilevers.
Attach cantilever legs to modesty
placing parts (B) into the holes on
the modesty.
Screw part (A) through cantilever
top rail into the holes in the top.
Tighten up parts (D) in modesty.
Apply part (F), cover cap,
over part (D).
Attach monitor using screws
provided by monitor supplier.
(Take time to review which
holes you need to use which is
dependent on monitor size.)
Apply part (G), hole plugs, to
outside of cantilever leg frame.
Clean using a damp cloth and mild detergent – do not use abrasive cleaners or bleach.
F
F
F
F
G
G
G
G
J
J
J
J
K
K
K
K
I
I
I
I
L
L
L
L
A
E
G
B
D
F
C
E
E
E
A
A
A
G
G
G
D
F
D
F
D
F
C
B
B
B
Remove the key
from the front of the
unit. Use this key to
unlock the unit and
lift the lid.