Lee & Plumpton Atmosphere Quad User manual

Assembly instruction leaflet no. 64a
Atmosphere Quad - Trumpet Base Assembly
Assembly steps
Step 1. Fixing the trumpet base.
1. Assemble the trumpet base using the
instructions provided in the trumpet pack.
2. Place top upside down on a soft clean
surface.
3. Align the trumpet base (part A) to the holes
on the underside of the top.
4. Fix the trumpet base to the top using the
four washers (parts C) and screws (parts B)
as shown.
5. Stand the product on the base and level the
accompanying desks to the height of the
Quad.
Step 2. Adding the brackets.
2a.Follow if fixing to slab ends
1. Position the brackets (parts D) so they are
aligned with the correct holes on the top as
shown.
2. Ensuring the brackets are pushed firmly
against the slabs, fix the brackets to top
using the washers (parts E) and screws
(parts F) as shown.
3. Fix the brackets to the slabs using the
washers (parts E) and screws (parts F) as
shown. It may be necessary to create
pilot holes before adding the screws.
2b.Follow if fixing to cantilever ends
1. Position the brackets (parts G) so they are
aligned with the correct holes on the top and
cantilever as shown.
2. Fix the brackets to the cantilever frame using
the bolts provided (parts H) as shown.
3. Fix the brackets to the top using the washers
(parts I) and screws (parts J) as shown.
Step 1.
Step 2a.
Slab not shown
Step 2b.
Cantilever not shown
Tools required
Pozi head screw driver
Allen key (4mm)
Part A
Part B
Part C
Part D
Part E
Part F
Part G
Part H Part I
Part J
Part E
Part F

Assembly instruction leaflet no. 64b
Atmosphere Quad - Round Leg Assembly
Tools required
Pozi head screw driver
Allen key (4mm)
Assembly steps
Step 1. Fixing the round legs.
1. Place top upside down on a soft clean surface.
2. Position the bolts (parts A) in the underside of the
leg plates (parts B) as shown.
3. Align the leg plates (parts B) to the holes on the
underside of the top.
4. Fix the leg plates to the top using the screws
(parts C) as shown.
5. Screw the legs (parts D) on to the leg plates.
6. Stand the product onto the legs. With one person
holding the unsupported edge of the product, level
to the height of the desks.
Step 2. Adding the brackets.
2a.Follow if fixing to slab ends. (One person must hold
the unsupported edge of the product until fixed).
1. Position the brackets (parts E) so they are aligned
with the correct holes on the top as shown.
2. Ensuring the brackets are pushed firmly against
the slabs, fix the brackets to top using the washers
(parts F) and screws (parts G) as shown.
3. Fix the brackets to the slabs using the washers
(parts F) and screws (parts G) as shown. It may
be necessary to create pilot holes before adding the
screws.
2b.Follow if fixing to cantilever ends. (One person must
hold the unsupported edge of the product until fixed).
1. Position the brackets (parts H) so they are aligned
with the correct holes on the top and cantilever as
shown.
2. Fix the brackets to the cantilever frame using the
bolts provided (parts I) as shown.
3. Fix the brackets to the top using the washers
(parts J) and screws (parts K) as shown.
Step 1.
Step 2b.
Cantilever not shown
Step 2a.
Slab not shown
Part B
Part C
Part D
Part E
Part F
Part G
Part H
Part I
Part K
Part J
Part A