Lee & Plumpton Meeting User manual

No.114 A/1883 Revision A 10/10/2018
1
www.leeandplumpton.co.uk
ASSEMBLY INSTRUCTIONS
RANGE Elect Coffee, Meeting and Poseur Tables
REF: Coffee Table, Round and Square Top 600 and 800mm wide,
Meeting Table Round and Square Top 600 and 800mm wide,
Poseur Table Round Top 600mm wide.
Read this leaet before
assembly
2 People
Required
COMPONENT PARTS
TOOLS REQUIRED BEFORE YOU BEGIN...
• Check you have all the tools and components required
• Keep children and animals away from small parts
• Ensure you have adequate space
• Assemble product on a at, clean surface
• Apply manual handling guidelines when building this item
• Pozi head screwdriver
Item 1
Brushed S/Steel Upright Leg
Qty,1
A/1785, A/1786, A/1787
Meeting Table Round and Square Top 600mm wide shown.
Item 3
Hex Head Screws
Qty 4
A/1785, A/1786, A/1787
Item 4
3/4” x 10g Pan Pozi BZP
Qty 8
F/0475
Item 2
X-Frame
Qty,1
A/1785, A/1786, A/1787
Item 5
Elect Table Top
Qty,1
1222, 1223, 1224, 1225
Item 6
Base Plinth
Qty,1
A/1785, A/1786, A/1787

No.114 A/1883 Revision A 10/10/2018
2
STEP 1
ASSEMBLY INSTRUCTIONS
CARE AND MAINTENANCE
STEP 2
STEP 3
Hold the Upright Leg (1) vertically.
Both ends are identical so it does
not matter which end is up.
Place the X-Frame (2) onto the
Leg and attach it with Screws (3).
Fully tighten the Screws.
3
1
Clean using a damp cloth and mild detergent – do not use abrasive cleaners or bleach.
Lay the Top (5) upside down on a
at, soft surface. Ensure all holes
are free of debris.
Turn the Leg upside down and
align the Holes in the X-Frame(2)
with the Pilot Holes in the Top (5).
Attach the Leg to the Top with
Screws (4). Do Not Tighten any
Screws until all Screws are in
place.
Fully tighten the Screws.
With the Table/Leg assembly
still on the oor, attach the
Base Plinth(6) to the Leg with
Screws(3).
Fully tighten the Screws.
Turn the Table the right way up.
2
4
2
5
Pilot Holes
3
1
6