Lennox Hearth Products Leveling Leg Field Fix Kit MPE-27 User manual

HEARTH PRODUCTS
KITS AND ACCESSORIES
INSTALLATION INSTRUCTIONS FOR MPE-27 LEVELING LEG FIELD FIX KIT (CATALOG NUMBER - H5808)
GENERAL INFORMATION
This kit was designed to provide an alternate leg configuration for use when previously used bracketed legs may interfere with tightly framed
installations.
Kit Contents:
Rubber Legs - Four (4), Sheet Metal Screws - Four (4), Instruction Sheet - One (1).
Tools Required:
Phillips screwdriver, or Drill-Driver with Phillips Bit.
INSTALLATION INSTRUCTIONS
Disconnect power and allow the electric fireplace to cool before starting any work.
Step 1. Tilt the unit back and rest it on its rear panel.
Step 2. Unscrew the eight (8) screws and remove the four (4) leveling brackets with legs from both sides of the fireplace (
see Figure 1 ).
Step 3. Remove the four existing screws from the bottom of the fireplace and discard.
Step 4. Attach the provided rubber legs with provided sheet metal screws to the fireplace bottom, using the existing mounting location (
Figure 1 ).
Step 5. Return the fireplace to its upright position.
MPE-27 LEVELING
LEG FIELD FIX KIT
750,245M
REV. N/C 02/2007
Figure 1
Existing Mounting Hole
And Location Of New Rubber Leg
Unit Resting On Rear Panel
Existing Leveling Leg
With Bracket
Printed in U.S.A. © 2007 by Lennox Hearth Products
P/N 750,245M REV. N/C 02/2007
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information. LHP
1110 West Taft Avenue
Orange, CA 92865
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.