Manrose FAN2040 User manual

Installation Instructions Specifications are subject to change without notice Page 1
[e-mail] | www.ventair.com.au Distributed by Simx Limited
Commercial Fans and Fan Kits
Thank you for purchasing this quality axial fan or fan kit.
To ensure correct function and safety, please read all instructions before using the product and keep all instructions for future reference.
Description Product Code
Wall/Ceiling Fan
(standard switching)
300mm FAN2040
230mm FAN0374
Through Wall Fan Kit
(standard switching)
300mm FAN2042
230mm FAN0455
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electrical shock and personal injury.
Model Cut -Out Size A B C D E F G H
FAN2040 310 362 156 81 75 300
FAN0374 265 586 141 75 66 230
FAN2042 310 350 50 230 375 298 156 81 362
FAN0455 265 286 30 250 375 248 141 75 586
DIMENSIONS (mm)
Note: Grille cut-out size is a nominal diameter for a circular cut-out.
SPECIFICATIONS
Duct
(mm)
Max.
Fan Watts
(W)
Max.
Fan Pressure
(Pa)
Free Air Fan Performance Specific
Fan Power
(W/l/s)
Sound
dB(A)
(l/s) (m3/hr)
300 82 60 306 1100 0.27 60
230 45 50 152 550 0.30 50
TECHNICAL
Supply Max. Operating Temp IP Rating Motor Housing Impeller & Outer Rotor Ducting - 375mm
220-240V AC, 50Hz 50°C IPX4 Die cast aluminium PBT plastic Aluminium Semi-Rigid
Compliance: AS/NZS60335-2.80:2016
A
A
E
D
C
B
A
D
F
C E H
BG
C
Wall/Ceiling Fans Through Wall Fan Kits

Installation Instructions Specifications are subject to change without notice Page 2
[e-mail] | www.ventair.com.au Distributed by Simx Limited
Commercial Fans and Fan Kits
AXIAL FAN OR FAN KIT INSTALLATION AND ELECTRICAL CONNECTION MUST
BE CARRIED OUT BY A REGISTERED ELECTRICIAN
BEFORE INSTALLING THE AXIAL FAN OR FAN KIT, MAKE SURE YOU HAVE TURNED OFF THE MAIN ELECTRICITY
SUPPLY. DO NOT TURN IT BACK ON UNTIL THE AXIAL FAN OR FAN KIT IS FULLY
INSTALLED AND READY TO USE.
ALL ELECTRICAL WORK MUST BE CARRIED OUT BY A REGISTERED ELECTRICIAN IN ACCORDANCE
WITH THE LATEST WIRING RULES AS/NZS3000.
CAUTION
• Before use, please check that the supply voltage and that of the appliance are the same (see product rating label).
• All wiring and wiring connections must comply with all current national wiring rules and regulations including AS/NZS3000:2017, or latest
edition thereof.
• Any changes or modifications made or attempted to this product, without the prior written approval of the manufacturer, will void any and all
stated warranties.
• This fan is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they are capable of, and have been given supervision or instruction concerning use of the appliance by a person responsible
for their safety.
• Children should be supervised to ensure that they do not play with the fan.
• In case of damage to the supply cord, switch off the device and do not tamper with it. Damaged supply cords must only be repaired or
replaced exclusively by the manufacturer or by an appointed representative. Failure to comply with the above may endanger the safety of
people and cause possible damage to the whole system.
• Precautions must be taken to avoid the back-flow of gases into the room from the open flue of gas or other fuel-burning appliances.
IMPORTANT
• This axial fan or fan kit is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Keep combustible materials away from the
fan and keep them away from the sides and rear.
• For best results the fan or fan kit should be fitted as high on the wall as possible, or if preferred, on the ceiling.
• Do not use near or in the immediate vicinity of a bath or swimming pool or any wet areas.
• When installing fan through an external wall, an external wall grille must be fitted at all times.
• This fan or fan kit is double insulated and does not require an earth.
• To protect against electric shock, do not immerse cord or plug in water or any other liquids.
• Do not insert or allow foreign objects to enter any ventilation openings, as this may cause an electric shock, fire or damage to the fan.
• Do not put fingers or foreign objects into the grille while in operation.
• Any changes or modifications made or attempted to this product, without the prior written approval of the manufacturer, will void any and all
stated warranties.
• To prevent overheating of this fan, keep the air inlets and outlets clean and free of anything that may cause blockage. Check all inlets and
outlets from time to time to ensure it is clear of any dirt or dust accumulation. DO NOT COVER.
• Do not use it in areas where gasoline, paint, or flammable liquids are used or stored.
• This product contains recyclable materials. Do not dispose of this product as unsorted council waste. Please contact your local council for the
nearest collection point.

Installation Instructions Specifications are subject to change without notice Page 3
[e-mail] | www.ventair.com.au Distributed by Simx Limited
Commercial Fans and Fan Kits
INSTALLATION
1. Cut a hole in the wall to suit the fan and duct. Please note that the maximum hole size is equal to the diameter of duct. If the fan is to be fixed
in the ceiling ensure that the hole is between the joists.
2. Fit suitable ducting flush to the plaster.
3. Remove the cover from the fan by removing the two small screw caps on the front cover and remove the two
retaining Philips screws.
4. Hold the body of the fan against the wall or ceiling and mark the four screw holes and the cable entry.
IMPORTANT: Ensure that the fan is square on wall or ceiling.
5. Bring power cable into position, as marked. Allow an extra 350mm protruding to facilitate connection. Fan should
only be installed by fixed wiring, a flexible cord should not be used.
6. When installing the external grille first take the grille insert out using a flat screwdriver and then drill 4 holes in the corners, mark screw holes
on the wall, and fix external grille.
WIRING
EXTRACT ONLY INPUT ONLY
NUMBER
TERMINALS
LIVE IN
NEUTRAL IN
LIVE IN
NEUTRAL IN
POWER
SUPPLY

Installation Instructions Specifications are subject to change without notice Page 4
[e-mail] | www.ventair.com.au Distributed by Simx Limited
Commercial Fans and Fan Kits
Manrose is proudly distributed by Ventair Pty Ltd
4 Capital Place, Carrum Downs, 3201 VIC, AUSTRALIA.
Technical Support [phone]
COMMFAN 2106
Manrose by Ventair Pty Ltd
4 Capital Place, Carrum Downs VIC 3201, AUSTRALIA
Technical Support: 1300 665 926