MD SPORTS SG010Y22039 User manual

MODEL/MODELO
SG010Y21033
www.medalsports.com877-472-4296
Assembly Instructions
MODEL
SG010Y22039

English
LIMITED 90 DAYS WARRANTY
SG010Y22039 1
(Continued on the next page) www.medalsports.com
www.medalsports.com
This product is covered by a limited warranty that is effective for 90 days from the date of purchase. If, during the limited
warranty period, a part is found to be defective or breaks, we will offer replacement parts at no cost to you, the customer.
The only exceptions to the warranty include mainframes, table tops, playing surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage, alteration, misuse, abuse, accidental
damage or neglect.
This Limited Warranty gives you specific legal rights and you may also have other rights vary from one State (province) to
another.
A PURCHASE RECEIPT (or other proof of purchase) will be required before any warranty service is initiated. For all
requests for warranty service, please feel free to contact our Consumer Service Department.
Please be aware of your product’s Limited Warranty for the return/refund policy from the store, We, at Medal Sports,
cannot handle the product which is out of product’s limited warranty since we only provide available parts. Thank you!
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE!
MD SPORTS
877-472-4296
Customer Service Toll Free
Please Contact
Mon.-Fri., 9:00 a.m. to 5:00 p.m. EST
For additional resources and Frequently Asked Questions, please visit us at
DO NOT RETURN TO STORE
WE ARE READY TO HELP

English
TOOLS REQUIRED
SG010Y22039 2(Continued on the next page) www.medalsports.com
This product is intended for INDOOR use only.
Wipe with a clean cloth wrung in water or in a solution of water and a neutral detergent.
Adult supervision is required for children playing this game.
1.
2.
3.
- Not Included
- Not Included
- Included
RECOMMENDED
IMPORTANT NOTICE
Adult assembly required.
CHOKING HAZARD - This item contains small parts. Not suitable for children under 3 years.
WARNING
Phillips Screwdriver
Standard (Flat Head Screwdriver)
Wrench
Electric Screwdrivers may be helpful during assembly; however, please set a low
torque and use extreme caution.
No children in assembly
area
Keep away from pets in
assembly area Do not use or keep
product outdoors. For
indoor use only. No
wet/humid conditions.
Power Tools: Set to Low Torque
High Torque Over Tightened

Mainframe
1
x1
FOR FIG. 1
PART NUMBER FIG. NUMBER
QUANTITY
PART
PART NAME
English
PARTS IDENTIFIER
SG010Y22039 3(Continued on the next page) www.medalsports.com
PRE-INSTALLED PARTS
Scoring Sensor Wire
Electronic Scorer Electronic Scorer Face Plate EVA Pad - A
EVA Pad - B
P2
x2
FOR FIG. 2 P3
x1
FOR FIG. 1 P4
x4
FOR FIG. 3
P1
x1
FOR FIG. 3
FOR FIG. 3
P5
x1
FOR FIG. 2
Rim
2
x2
Ball Return
3
x2
FOR FIG. 2
Rim Net
4
x2
FOR FIG. 4
ACCESSORIES
Basketball
5
x2
Air Pump
6
x1
HARDWARE
M6 Nut
A2
x4
FOR FIG. 2 A3
x1
A4
M6x14mm Bolt
A1
x4
FOR FIG. 2
Wrench
P6
x2
FOR FIG. 1
Hanger
P7
x4
FOR FIG. 1
M5x7mm Bolt EVA Pad - C
P8
x2
FOR FIG. 3
6
Needle

ASSEMBLY
English
PRE-INSTALLED PARTS
SG010Y22039 4(Continued on the next page) www.medalsports.com
EVA Pad
Find a clean, level place to begin the assembly of your product.
Verify that you have all listed parts as shown on the part list pages. If any parts are missing, call our customer service.
1.
2.
BEFORE ASSEMBLY
P6
P3
1
FIG. 1
1
x1
x1
P3
x2
P6
x4
P7
Pre-installed
Pre-installed
Pre-installed
P6
EVA Pad - D
P9
x4
FOR FIG. 3
EVA Pad - E
P10
x4
FOR FIG. 3
P7 P6

English
ASSEMBLY
SG010Y22039 5(Continued on the next page) www.medalsports.com
1
P2
P2
3
REAR VIEW
3
2
A1
2
2
3
3
FIG. 2
2
x2
x2
3
x4
A1
x4
A2
x1
A3
x2
P2
Pre-installed
1
1
A2
3
A2
SIDE VIEW
A1

English
ASSEMBLY
SG010Y22039 6(Continued on the next page) www.medalsports.com
4
2
4
2
42
FIG. 4
4x2
Sensor Wire
P2 P4
Note: Insert the sensor wires into
the electronic scorer (P1).
P4
P8
FIG. 3
P1
x4
x1
P4
x1
P5
Pre-installed
Pre-installed
Pre-installed
x2
P8
x4
P9
Pre-installed
Pre-installed
x4
P10
Pre-installed
P1
P5
P9
P10
4
2
Note: Attach the part with larger meshes
to the rim.
4

FIG. 5
BALL STORAGE
English
ASSEMBLY
SG010Y22039 7(Continued on the next page) www.medalsports.com
STEP 1
STEP 2
5
5
Hangs easily over any
standard size door.
3
P6
5x2
2
3

English
ELECTRONIC SCORER OPERATION
SG010Y22039 8(Continued on the next page) www.medalsports.com
P1
The batteries must be installed according to their correct polarization (+ and -).
Please clean the battery contacts and also those of the device prior to battery installation.
If the game will not be used for a long period of time, we recommend removing the batteries.
a.
b.
c.
REMINDING
Requires 3 pcs 1.5V “AAA” batteries (not included).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or rechargeable (ni-cad, ni-mh, etc.) batteries.
1.
2.
3.
WARNING
Battery Box: Unscrew the bolt using a screwdriver and open the battery box. Insert 3 pcs 1.5V “AAA” batteries (not
included) in the sequence of polarity as shown on the inside cover. Then close the cover using a screwdriver.
BATTERY INSTALLATION

English
ELECTRONIC SCORER OPERATION
SG010Y22039 9(Continued on the next page) www.medalsports.com
GAME DESCRIPTIONS
Turn the power ON using the ON/OFF switch. The default game time is 60 seconds.
The game begins after a 3 seconds countdown.
Each player must score on their own hoop - Player 1 or Player 2.
All shots are worth 2 points until the final 15 seconds, when each shot is worth 3 points, see how many points you can
get in the timing period.
The winner is the player who scores the most points in one minute on their own hoop.
If the player needs to continue the game, a ball needs to be shot into the basket or it is restarted, the player can restart
the game.
1.
2.
3.
4.
5.
6.
Please turn the power OFF using the ON/OFF switch when it is not in use.
After a 5 minutes period of inactivity, the game will automatically power off. Pressing the “ON/OFF” key will return the
game.
1.
2.
NOTES:
P1

English
DISCLAIMER
SG010Y22039 10(The last page) www.medalsports.com
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment.
WARNING
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
This device complies with the Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and (2) This device must accept any interference received,
including interference that may cause undesired operation.
For additional resources, please contact Medal Sports Corp.
1300 Melissa Drive, Suite 124, Bentonville, AR 72712
Toll Free: 877-472-4296
NOTE
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
•
•
•
•

www.medalsports.com