Medline MDS86410SGB Installation and operating manual

Stand and Go Walker
MDS86410SGB
ASSEMBLY AND
SAFETY GUIDE.

2MEDLINE |MDS86410SGB (Rev: 03-07-19)
E
D
C
A2 Front legs with wheels
B2 Back legs without wheels
CWalker frame
D2 Handles with handgrips
E2 Triangular knobs
What’s Included:
B
AA

1-800-MEDLINE (633-5463) |medline.com 3
This guide applies to the following rollator:
Item Number Description Frame
Color Weight Capacity
MDS86410SGB Stand and Go Walker Blue 250lbs
(113kg)
Safety Instructions
For Safety, these precautions must be taken
when using this products.
Before Each Use make sure:
√ Walker is adjusted to the correct height.
√ Locking mechanisms and spring buttons are fully engaged.
√ Wheels are in good condition.
√ Make sure the walker sits level.
Always Use extreme care when using a walker. Avoid all potential
safety hazards including slippery, uneven or soft surfaces and
objects in path.
DO NOT use on stairs. The use of walkers in water (showers,
bathtubs, pools etc) may corrode the working mechanisms of your
walker. The use of a corroded walker may result in damage to the
walker and/or injuries to the user.
DO NOT exceed the maximum weight capacity of your walker.
DO NOT use your walker if you have any handicaps or disabilities
or using medications etc that would impair of interfere with safe
usage of this product. Failure to follow the above instructions may
result in serious injury.

4MEDLINE |MDS86410SGB (Rev: 03-07-19)
First: Open the Walker Seat
Assembly
IMPORTANT NOTE:
Proceed with caution when
assembling as there
are areas around the
moving parts that could
potentially pinch fingers.
1
Remove the walker components from shipping carton. Then, in
an upright position, unfold the walker frame and place on its side.

1-800-MEDLINE (633-5463) |medline.com 5
Now: Install the Legs
Insert one front leg with wheel into the base of the walker.
Ensure the push button is engaged. Wheel should always
be on the outside of the walker frame.
2
Repeat with the other front leg and make sure the push
button is engaged.
Insert the back leg (without wheel) into the frame of the walker.
4
Repeat with the other back leg. Ensure both legs are locked in
place before use.
1
3

6MEDLINE |MDS86410SGB (Rev: 03-07-19)
Insert one handle into the
base of the walker frame.
Slide up or down to adjust to
your height preference, then
insert the 3 point knob into
the walker and tighten.
1 2
3
Repeat with the other handle.
Ensure both hand rests/grips are tightened before use.
Finally: Install Handles

1-800-MEDLINE (633-5463) |medline.com 7
Push locking button until lock shows red. Gently press down to
lower the handles into place.
Lift up on the handles lightly. The walker handles will rise to
walking height. Make sure the locks show green to indicate they
are locked into walking position.
1
3
Pull the unit around the body & use the hand grips & balls to
help you stand straight up.
2
How to Use - From Sitting Position
GREEN
RED

Not made with Natural Rubber Latex.
Some products may not be available for sale in Mexico or Canada. We reserve the right to correct any errors that may
occur within this brochure. © 2019 Medline Industries, Inc. All rights reserved. Medline is a registered trademark of
Medline Industries, Inc.
MDS86410SGB (Rev: 03-07-19)
BLOG
Medline Industries, Inc.
Three Lakes Drive, Northfield, IL 60093 USA
1-800-MEDLINE (633-5463)
medline.com | [e-mail]