METHVEN 439860 User manual

Periodically. the aerator should be removed as shown below, and cleaned under running water.
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand Australia UK
www.methven.com
ISSUE A
Technical Specifications:
Operating Pressure:
Min: kPa/ bar
Max: kPa/ bar*
Operating Temperature:
Hot: Max °C*
Cold: Min °C
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement
at www.methven.com
Wall Mounted Spout
Installation Guide
USE PARALLEL FITTINGS ONLY
Care and Cleaning:
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.

Step
The wall lining hole should be cut or
Installation:
•
Step
Install a female 1/2” BSP elbow (not supplied)
in the wall cavity such that the front face of the
•
elbow is mm behind the front face of the
stud.
0 - 15mm
35-40mm
25 max
Finished wall thickness
finished as per the dimensions shown
in the diagram on the right.
Measure the distance from the front of
•
the finished wall surface to the front
face of the elbow.
Cut the inlet connector so that the thread
•
length is mm longer than the measured
distance.
Step
Apply thread tape to the inlet connector
•
to ensure a good seal.
Screw inlet connector into the elbow such
•
that the front face of the hex shoulder is mm
proud of the finished wall surface.
3 max
Step
Ensure the faceplate o-ring is assembled
•
to the faceplate.
Slider the faceplate onto the spout body and
•
position with the notch towards the bottom.
Apply silicone to the faceplate to create a
•
seal with the finished wall surface.
Push the spout and faceplate onto the inlet
•
connector and secure in place by tightening
the grub screw firmly using the hex key.
Inlet Connector
Faceplate
Faceplate O-ring
Spout
Grub Screw
Hex Key
½
" BSP Female Elbow
(Not Supplied)
IMPORTANT: Please read all of the instructions before installation.
General:
•
•
•
•
•
•
•
Methven recommends this product is installed by a licensed plumber in compliance with
all relevant regional regulations.
All pipe work must be thoroughly flushed prior to the installation of the spout
After installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as
per regional regulations.
This spout is not recommended for use in uncontrolled heating systems such as wet-backs
or solar heating units unless a suitable tempering valve is fitted.
If limited water flow is experienced, locate aerator and clean away foreign material as
required.
It is the responsibility of the installer to ensure a waterproof seal is achieved between the
product and mounting surface. If in doubt about the quality of the seal, remove the
product and reinstall.