METHVEN DEVA ETHOS ETH106 User manual

ETH106
Technical Specification
METHVEN UK LIMITED
METHVEN EXPERIENCE CENTRE
3/3A STONE CROSS COURT
YEW TREE WAY
GOLBORNE
WARRINGTON
WA3 3JD
UNITED KINGDOM
Warranty Information
Proof of purchase will be required.
The guarantee does not cover faults or damage caused by
incorrect installation and/or maintenance, ordinary wear and
tear, water composition, etc.
*Please see www.deva.org.uk for full terms and conditions of warranty
Cleaning
Your product has a high-quality finish and should be treated
with care to preserve the visible surfaces. Never use abrasives or
abrasive cleaning agents to clean this product clean regularly
with contamination free warm water and a damp soft cloth. Do
not use products containing chlorine bleach or hydrochloric
acid as these can damage the product.
ETHOS BATH SHOWER MIXER
Installation Guide
Operating Pressure
Min:
Max:
Operating Temperature
Hot:
Cold:
0.5 Bar
5.0 Bar
65⁰C
5⁰C
Inlet Connections
3/4” BSP
INST-ETH106-V1
TEL: [phone]
FAX: [phone]
EMAIL: s[email protected]
www.methven.com
We have a policy of continuous improvement and reserve the
right to change specifications without notice.

Please read all of the instructions before installation.
General
Installation Instructions
Methven recommends this product is installed by a competent person in
compliance with all relevant regional regulations.
After installation all connenctions must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a
safe temperature as per regional regulations.
It is the responsibility of the installer to ensure a waterproof seal is
achieved.
1) Remove the back nuts and back
nut washer from the threaded tails.
2) Push the mixer tails through the
holes in the bath, ensuring that the
base rings and base ring washers are
correctly positioned, fully covering
the mounting holes.
3) Place the back nut washer and
back nuts back onto the tails, under
the bath, and screw up until the
tap is secured in position (do not
overtighten). Please note additional
sealant can be used if required.
4) Connect the water supply pipes
to the tails and tighten, an adequate
sealing method should be used to
create a watertight seal.
5) Identify a suitable location for the
wall bracket, so that the hose will not
be under tension when fitted. Attach
to the wall using either the plugs and
screws supplied or other suitable fittings
for the specific installation.
6) Fit a hose washer into each end of
the hose, connect the handset to the
cone shaped end and the other end
to the hose outlet on the mixer.
7) Reinstate the water supply and test
for leaks.