METHVEN SATINJET WALL SHOWER User manual

www.methven.com
SATINJET®WALL SHOWER/ARM
Installation Guide
Technical Specifications:
Operating Temperature:
Hot: Max 60°C / 140°F*
Cold: Min 5°C / 40°F
Suitable for use with high pressure
water supply
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
Inlet Connections:
All ½" BSP
Operating Pressure:
Min: 35kPa/0.35bar
Max: 500kPa/5bar*
AUSTRALIA ONLY
Min: 150kPa/0.5bar
Max: 500kPa/5bar*
SHOWER ARMS WALL SHOWERS
Operating Pressure:
Min: 150kPa/1.5bar
Max: 500kPa/5bar*
Operating Pressure:
Min: 35kPa/0.35bar
Max: 500kPa/5bar*
AUSTRALIA ONLY
Min: 150kPa/0.5bar
Max: 500kPa/5bar*

13 14 16
IMPORTANT:
Please read all of the instructions before installation.
GENERAL:
• This product must be installed in compliance
with all relevant regional regulations.
• It is the responsibility of the installer to
ensure a watertight seal is achieved.
• Care should be taken when connecting wall
shower to shower arm to not damage the flow
restrictor in the wall shower.
• All outlets used primarily for personal hygiene
shall deliver water at a safe temperature as
per regional regulations.
Some low flow showers may not be suitable
for use with gravity-fed water heaters, low
pressure supply networks, instantaneous
water heaters, tempering valves and
thermostatic mixing valves.
Filter
Washer
Methven Satinjet
Wall Shower
(If Supplied)
CARE AND CLEANING:
Methven Shower
Arm (If Supplied)
Plumbing Tape
BSP Nipple/NPT
• Never use abrasives or abrasive cleaning agents to clean this product. To clean the chrome-plated
surface use contamination free warm soapy water and a damp soft cloth.
• Lime deposits can be prevented from forming on the faceplate by wiping immediately after use. If
shower performance is compromised by the build-up of lime-scale, soak in limescale remover for up
to 10 minutes. Do not attempt to remove limescale with sharp objects or abrasives. Do not use
products containing chlorine bleach or hydrochloric acid as these can damage the shower. Always
rinse the shower thoroughly after cleaning to remove cleaning products that can damage the shower.
• Clean face plate using a brush with soft bristles.
• Do not use any sharp objects to clean nozzles.
• Clean filter washer located in the ball joint periodically.
439925 ISSUE F