METHVEN TUROA User manual

Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Periodically the stream shaper should be removed as shown below and cleaned under running water.
Care and Cleaning:
 ISSUE A www.methven.com
Technical Specifications:
Operating Pressure:
Min: 35kPa/0.35bar
Max: 1000kPa/10bar*
Optimum: 150kPa/1.5bar - 500kPa/5bar
Operating Temperature:
Hot: Max 80°C*
Cold: Min 5°C
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
TŪROA WALL MOUNTED BATH SPOUT
Installation Guide

•
Step 1
Wall lining hole should be cut or finished as
per the dimension shown in the diagram on
the right.
Cut off the threaded nipple 15±2mm from
the wall lining and apply thread seal tape
to ensure a good seal.
IMPORTANT: Before you begin, turn off the water supply.
•
Step 2
Ensure seal is assembled to
faceplate.
If necessary apply silicone to the
seal to create a seal with finished
wall surface.
Slide the faceplate over the nipple.
Slide washer over the nipple.
Secure faceplate in place by
screwing the inlet connector onto
the nipple.
•
•
•
•
Step 3
Push the spout onto the inlet connector and
secure in place by tightening the grub screw
firmly using the hex key provided.
•
•
•
•
•
•
IMPORTANT: Please read all of the instructions before installation.
General:
Methven recommends this product is installed by a licensed plumber in compliance with all
relevant regional regulations.
After installation all connections must be checked for leaks.
All outlets used primarily for personal hygiene shall deliver water at a safe temperature as per
regional regulations.
It is the responsibility of the installer to ensure a waterproof seal is achieved between the
product and mounting surface. If in doubt about the quality of the seal, remove the product and
reinstall using silicone to ensure a seal is achieved.
26mm max
15±2mm
Grub Screw
Hex Key
½" BSP Nipple
(Not Supplied)
Faceplate Seal
Faceplate
Washer
Inlet Connector
Spout