METHVEN SATINJET SQUARE OVERHEADDRENCHER User manual

SATINJET SQUARE OVERHEAD
DRENCHER WITH WALL/CEILING ARM
INSTALLATION GUIDE
TECHNICAL SPECIFICATIONS
Operating Pressure:
Min 35 kPa, Max 500 kPa.
Recommended installation of a pressure
limiting valve if supply exceeds 500kPa.
Operating Temperature:
Max 70°C.
NB: New Zealand Building Code Clause G12 -
Water Supplies specifies all outlets used
primarily for personal hygiene shall deliver
water at a safe temperature.
Issue A
433236
Methven warrants this product against manufacturing defects and that it is suitable for use
under the operating conditions specified in this instruction sheet.
For your warranty please refer to www.methven.com or call Customer Service
New Zealand
0800 804 222
Australia
1300 638 483
USA
1800 975 5409
UK
0800 195 1602

Water contains lime which remains on the surface
after the water has evaporated. These lime
deposits can be prevented from forming by wiping
immediately after use.
To clean the chrome-plated surfaces use a soft
cloth, soap and warm water. Never use cleaning
agents that contain a corrosive acid or a scouring
additive.
CLEANING
NOTE: Removal of the flow restrictor in the shower rose may be necessary to optimise flow performance in low or
unequal pressure systems only
Install a ½” male threaded connection at the desired
height on wall/or position on ceiling, ensuring that
a minimum of 10mm of thread protrudes past the
finished wall.
FOR WALL ARM - RECOMMENDED MINIMUM HEIGHT
2100MM FROM FLOOR LEVEL
Slide chrome trim ring onto the appropriate end of
the arm. Screw the arm onto the ½” connection using
plumbers tape or similar to ensure a reliable seal.
Position the arm vertically and push trim ring into
place.
Remove the protective cap from the showerhead ball
joint and screw the unit onto the wall/ceiling arm
ensuring the filter washer is in place.
Tilt and rotate the shower head to the desired position.
Ball Joint
Filter Washer
Vertical
Trim Ring Arm
Min 10mm
Max
Ø 25mm
1. 2. 3. 4.
5.
NOTE - If assembling a showerhead to a pre-existing arm skip to step 4