METHVEN KRSRCPAU User manual

www.methven.com
Technical Specifications:
Inlet Connections:
All ½" BSP
* Regional specific regulations apply.
Please refer to your warranty statement at
www.methven.com
ROUND RAIL
Installation Guide
Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Periodically the filter washer should be removed from the end of the shower hose and cleaned.
Care and Cleaning:
439994 ISSUE A
Elbow Installation (if supplied):
13±2mm
26mm max
Step 1
• Install ½” BSP nipple at the desired elbow position.
• Wall lining hole should be cut or finished as per the
dimension shown in the diagram on the right.
• Cut off the threaded nipple 13±2mm from the wall lining
and apply thread seal tape to ensure a good seal.
Step 2
• Screw the elbow onto the nipple ensuring that
the o-ring is sufficiently compressed to create a
watertight seal.
• Ensure that the elbow is oriented vertically with
the outlet oriented downwards.

Step 1
• Mount the rail connectors in desired position with
the screws. Check the connectors are vertically
aligned
Step 3
• Check the grub screws in the rail
brackets are wound out.
• Match the rail brackets to the
connectors and push rail into place.
• Tighten grub screws top and bottom
624mm
Rail
Slider
Elbow
Grub Screw
Grub Screw
Mounting
Screw
Mounting
Screw
Rail Connector
Rail Connector
• This product must be installed in compliance with all relevant regional regulations.
• It is the responsibility of the installer to ensure a waterproof seal is achieved between the
product and mounting surface. If in doubt about the quality of the seal, remove the product
and reinstall using silicone to ensure a seal is achieved.
• All pipe work must be thoroughly flushed prior to the installation of the hose.
• After installation all connections must be checked for leaks.
• All outlets used primarily for personal hygiene shall deliver water at a safe temperature as
per regional regulations.
IMPORTANT: Please read all of the instructions before installation.
General: