METHVEN Kaha 01-7157 User manual

JULY 2011 MA017157
Kaha Shower Mixer with Diverter
01-7157
IMPORTANT
Please read all of the instructions before installation
Installation Guide
Ceramic Cartridge Adjustment
Do not remove the ceramic cartridge from the body assembly while carrying out the
following adjustments. Note, the cartridge is factory set for maximum temperature.
-
+
-
+
1.5mm Hex key
Do not hydrostatic test the installation with this mixer installed. Damage to the
ceramic cartridge may occur.
“In situ” testing
WMKA21005
Methven Australia Pty Ltd
ABN 15 104 813 390
Melbourne, Australia
www.methven.com
www.methven.com
Use of this product is recommended for domestic and commercial applications.
All pipework must be thoroughly flushed prior to the installation of the mixer.
Inline filter washers must be installed on both hot and cold supplies to prevent
foreign particles damaging the ceramic cartridge.
Do not remove the ceramic cartridge from the mixer when installing.
Methven recommends a licensed plumber carry out all installations in compliance
with the requirements of AS/NZS 3500. This product complies with AS/NZS 3718
regulations.

Technical Specifications
Avoid restrictive piping, fitting or sharp angled bends when plumbing the mixer. Do
not hydrostatic test the installation with this mixer installed. Damage to the ceramic
cartridge may occur.
Note: It is recommended to apply a bead of clear silicone sealant on back of the face
plate before fixing to finished wall surface.
Inlet Connections: All 1/2" BSP
Operating Pressure: 150kPa - 500kPa
Operating Temperatures: Recommended hot water supply 50°C,
maximum 70°C. AS 3500 requires all hot
water supplies to any sanitary fitting to be
tempered to 50°C.
Ø
Ø
We recommend that this product is installed by a licensed plumber.
75 ± 5mm
Ø
Remove Cover until Step 4