METHVEN TUROA ACCESSORIES User manual

Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand
0800 804 222
Australia
1300 638 483
UK
0800 195 1602
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Care and Cleaning:
435570 ISSUE A www.methven.com
Please refer to your warranty statement at
www.methven.com
TŪROA ACCESSORIES
Installation Guide

IMPORTANT NOTE: Wall materials vary. The fixing kit supplied is suited for
use with a solid wall. For timber framed walls, please ensure the accessory
is fixed to a stud/noggin behind the wall. A suitable hollow wall fixing
should be used if a stud/noggin is not available.
Installation:
Step 1
• Position your accessory in the desired
mounting location. Ensure the accessory is
level and mark the location by scribing a
circle around the trim ring(s).
• Remove the trim ring(s) and wall mounting
plate(s) from the accessory by loosening the
grub screw(s) underneath.
Step 3
• Insert the wall mounting plate into the trim
ring, and screw both to the wall. Check
that the trim ring is flush against the wall.
Step 2
• Using the trim ring as guide, mark the
location of the screw holes. Ensure the holes
are aligned vertically.
• Drill mounting holes - Note: Drill type and
size will depend on wall construction.
A 6mm hole is recommended for the wall
plugs supplied.
• Insert the wall plugs into the drilled holes if
required. Use a mallet to gently tap the plugs
in until flush with the wall surface if
necessary.
Step 4
• Push the accessory onto the trim ring(s) and
check the accessory is level. Loosen the
screws and adjust the mounting plate
position if required.
• Tighten grub screw(s) firmly with hex key
provided.
Grub Screw
Hex Key
Trim Ring
Wall Mounting Plate
Mounting Screws
Accessory