METHVEN AIO ACCESSORIES User manual

Methven warrants this product against manufacturing defects and that it is suitable for use
under the general operating conditions specified in this instruction sheet. However, regional
regulations apply and may affect your warranty. Please refer to www.methven.com or call
customer service for full details.
New Zealand Australia UK
www.methven.com
Never use abrasives or abrasive cleaning agents to clean this product. Clean regularly with
contamination free warm soapy water and a damp soft cloth.
Care and Cleaning:
Please refer to your warranty statement at
www.methven.com
AIO ACCESSORIES
Installation Guide
MA382270 - ISSUE A
*Single and Double Towel Rails available
in both 600mm and 900mm
Soap Dish Holder
Bathroom Shelf
All Methven accessories are constructed from brass, and are able to hold up to 5 kilograms.*
*(Bathroom Shelves are constructed from brass and stainless steel)
SEPT 2017
20mm
60mm 640 mm / 940mm
130mm
26mm
97mm
384mm
19mm
105mm

All Methven accessories are constructed from brass, and are able to hold up to 5 kilograms.
1.
IMPORTANT:
Installation:
Single Towel Rail (600mm and 900mm)
Towel Ring
Toilet Roll Holder
Robe Hook
2. Pre-drill the holes
Now drill into the marked measurements, right through the tiles into the wall.
3. Insert the wall plugs
Remove the tape and insert the wall plugs into your holes. If you need to, use a hammer to
gently tap the plugs in.
4. Remove the plates from your accessory
Using the Allen key provided, remove the plates from your accessory.
Please read all of the instructions before installation.
5. Screw the plates to the wall
Using your drill, screw the plates into the wall plugs so that they are flush with the tiles.
6. Check the plates are level
With your tape measure, check that the distance from the plates to the edge of the tiles below
them is the same. If not, then you will need to make adjustments. This will ensure your
accessory will look straight once it is installed.
IMPORTANT NOTE:
Wall materials vary. The accessory fixing kit supplied is suited for solid wall fixing. For timber
framed walls, pleasure ensure the accessory is fixed to a noggin/stud behind the wall. Where
stud/noggin is not available, please use suitable hollow wall fixing.
121mm
60mm
240mm
20mm
60mm 179mm
7. Attach the accessory to the wall
Finally, connect the accessory to the plates on the wall. Tighten it using the Allen key. Then
check that the accessory is level.
8. Check the levels
Finally, check that the accessory is straight, using your spirit level. If not, then you will need
to make some adjustments. Please refer to the following series of images for your
corresponding accessory.
20mm
60mm 640mm / 940mm
Please note that the plate will need to be installed vertically for the Robe Hook
Double Towel Rail (600mm and 900mm)
Measure and mark positions
Choose a position for your accessory. Measure the distance between the fixings on the base of
the accessory and transfer these measurements onto the wall. Measure an equal distance down
from the bottom of a tile and mark the measurements to make sure they are even and level.
20mm
70mm
49mm
20mm
110mm 640mm / 940mm