Mocka Arlo Coffee Table User manual

Arlo Coffee Table
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
1
WARNING: Any furniture that is not anchored to a wall has the potential to tip over in certain
circumstances, i.e. if a child attempts to climb up on the furniture or in the event of an earthquake.
Accordingly, we recommend that all furniture is anchored to a wall. We supply a free safety wall anchor
with all furniture sold and we recommend these are used to prevent your product tipping. The fixing device
provided should fit most wall types, but please note that different wall materials may require different fixing
devices from those supplied.
Phillips & Flathead screwdrivers required.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
bolt
x10
screw
x6
ABCD
GH
F
Hardware Supplied
dowel
x8
locking
nut x10
E
screw
x12
Allen key
x1
Cover
x6
Felt pad
x4

Arlo Coffee Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
2
12
Insert 6x bolts (C) into panel [1], and tighten with a screwdriver. Attach panels [3] and [4] to panel [1] with 4x dowels (A) . Secure with
6x locking nuts (D) and tighten with a screwdriver. Insert 6x covers (G)
into the holes of panels [3] and [4].
C
C
C
C
A
A
D
D
D
A
A
1
4
3
1
D
G
G
G
C
C
D
G

Arlo Coffee Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
3
34
Attach panel [2] to panels [3] and [4] with 4x dowels (A), and secure
with 6x screws (B). Tighten with an Allen key.
Insert 2x bolts (C) into each panel [5]. Attach panels [5] to panels [6] and
secure with 4x locking nut (D). Tighten with a screwdriver.
B
A
A
A
B
F
B
B
B
F
2
4
3
C
C
X2
D
D
D
D
5
6
5
5
6
B
B
D

Arlo Coffee Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
4
56
Attach the leg panels [5] and panels [6] to the bottom panel [2] with
12x screws (E). Tighten with a screwdriver.
Apply 4 x felt pads (H) to the end of panel [5] as shown.Once assembled
lift furniture into place, do not drag. You’re done,enjoy!
2
EE
E
E
EE
E
5
65
H
H
H
H
E
E
EE
E