Mocka Aspiring Cot User manual

Hardware Supplied
Side Panel
Cot Mattress Base
End Panel
WARNING: TO PREVENT FALLS,THE MATTRESS BASE
OFTHIS COT SHOULD BE ADJUSTEDTOTHE LOWEST
POSITION BEFORETHE CHILD CAN SIT UP
B C
A
x1
Allen key
x12
screw
x4
screw
Mocka Aspiring Cot
1
mocka.co.nz | mocka.com.au | PO Box 6171, Maroochydore, BC, 4558, QLD.
Assembly Instructions
Thank you for purchasing a Mocka Aspiring Cot.
Please follow the manufacturer’s assembly instructions in detail
to ensure the safety features of the cot are not compromised.

1
Find one of the side panels and attach to both end panels of the cot
using 4x screws (A) in the holes as shown.
A
A
x4
A
C
A
A
Mocka Aspiring Cot
2
mocka.co.nz | mocka.com.au
Assembly Instructions

2
Attach the cot mattress base at the required level using 4x screws (A)
as shown, and tighten all screws using the allen key (C).
A
A
A
A
x4
A C
Mocka Aspiring Cot
3
mocka.co.nz | mocka.com.au
Assembly Instructions

3
Slide the remaining side panel into place and attach using 4x screws
(A) in the holes as shown. Tighten all screws using the allen key (C).
A
A
A
A
x4
A C
Mocka Aspiring Cot
Assembly Instructions
4
mocka.co.nz | mocka.com.au

4
B
B
B
B
Turn the cot on the side and secure the base with 4x screws (B)
in the holes as shown. Tighten all screws using the allen key (C).
Mocka Aspiring Cot
Assembly Instructions
5
mocka.co.nz | mocka.com.au
B
C
4

Jolt Wardrobe
ASSEMBLY INSTRUCTIONS
5
mocka.co.nz | mocka.com.au
56
All done! Regularly check all screws are suitably tightened. Place the
correct size mattress into the cot before use. To clean use a damp
cloth, avoiding the use of detergents or abrasives. Once assembled lift
furniture into place, do not drag.
A
A
A
Mocka Aspiring Cot
Assembly Instructions
6
mocka.co.nz | mocka.com.au
OPTIONAL/MATTRESS HEIGHT ADJUSTMENT (please keep these
instructions handy for future reference)
To adjust mattress base settings, remove small plastic plugs. This will
require a small amount of force, please note these are not screws and
cannot be screwed out. You will need a screwdriver that fits into the
centre hole and possibly a hammer, or similar, to gently tap the end
until the plug pops out.
Repeat steps 2, 3 and 4 by removing the side panel and moving the
base to corresponding holes. Securely attach again in the adjusted
position.