Mocka Kirra Coffee Table User manual

Kirra Coffee Table
Assembly Instructions
Thank you for your purchase.
Please follow the instructions below for correct assembly.
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
1
Phillips & Flathead screwdrivers required.
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
bolt
x6
A B C D
E F GH
Hardware Supplied
dowel
x12
screw
x64
locking
nut x6
screw
x6
x8 x8
wheel wheel
screw
x20
WARNING: Any furniture that is not anchored to a wall has the potential to
tip over in certain circumstances, i.e. if a child attempts to climb up on the
furniture or in the event of an earthquake. Accordingly, we recommend that
all furniture is anchored to a wall. We supply a free safety wall anchor with
all furniture sold and we recommend these are used to prevent your product
tipping. The fixing device provided should fit most wall types, but please
note that different wall materials may require different fixing devices from
those supplied.

Kirra Coffee Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
2
12
3
3
4
1
Attach panels [3] and [4] to panel [1] with 6x dowels (A) and
secure with 6x locking nuts (D). Tighten with a screwdriver.
Insert 6x bolts (C) into panel [1]. Tighten with a screwdriver.
C
C
C
C
C
C
D
A
A
A
A
D
D
A
A
D
D
D

Kirra Coffee Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
3
3 4
Attach panel [2] to the unit with 6x dowels (A) and secure
with 6x screws (B). Tighten with a screwdriver.
Attach the legs [5] and [8] to panel [2] as shown using 20x screw (F) .Tighten
with a screwdriver.
3
3
2
2
4
5
8
5
5
5
A
A
B
B
A
B
A
B
B
B
F
F
F
F
F
F
F
FF
FF
F

Kirra Coffee Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
4
65X2
6
6
7
7
6
E
G
G
H
H
EE
EEE
EEE
EEE
7
E
G
G
H
H
EE
EEE
EEE
EEE
Attach 4x wheels (G) and (H) to panels [6] and [7] as shown, and secure with
32x screws (E). Tighten with a screwdriver.
Attach panels [6] and [7] as shown, starting with the back door first and
then the front door. Press the clip down on the back of the door to
assemble the door. Push the clip back up to lock into place.
Note: If the door is not sliding smoothly or
sitting straight, there is a screw in the
middle of the wheel on the bottom of each
door that can be tightened/loosened until
the door is sitting properly.
back
OK