Modena Argento Series User manual

User
Manual Book
Water Dispenser
Argento Series
DD 7170 S

2
Thank you for your trust in choosing MODENA products for your household
needs. With your satisfaction as our priority, we constantly aim to deliver
stylishly designed products equipped with state-of-the-art technology to
assist you in your daily activities.
This is your guidebook containing everything you need to know about our
product. Please reach out to us if you need further assistance or other
information via our Customer Care or our official website www.modena.com.

3
TABLE OF CONTENTS PAGE
INTRODUCTION 2
⚫Part 1 : Name of Parts 4
⚫Part 2 : Installation 5
⚫Part 3 : How to Use 7
⚫Part 4 : Maintenance 8
⚫Part 5 : Points of Attention 9
⚫Part 6 : Troubleshooting 11
⚫Part 7 : Specification 12

4
Fuse
Drip tray
Water tap
Cold water
indicator
On/off
Switch
Condenser
Part 1 : Name of Parts
Door
Water level
indicator
Hot water
indicator
Drain
valve

5
Please read this operation manual carefully before operating the appliance in order
to use the appliance properly and safely. Pay attention to the entire sign or warning
explained on the pictures or text.
1. Install the dispenser on an even and stable
surface. A minimum distance of 20 cm from
the wall must be provided.
2. Leave the appliance for 1 hour to stabilize
the refrigerant.
3. Insert the Z-pipe into the gallon and then
cover it with the lid.
4. Insert the gallon into the cabinet. Make sure
it is installed properly and close the door.
5. Connect the power cord to the power socket,
and turn on the red switch (heater) located
behind the appliance. Make sure that the
socket/electric source has been grounded to
prevent electric leakage. Turn on the switch
located behind the appliance.
6. For initial use, the inside of the appliance
must be cleaned. Press the hot and cold
water button. Make sure the water dispenses
out of the tap. After that, wait around 20
minutes, then remove the gallon and drain
the water by opening the drain valve. Make
sure the power cord is unplugged from the
power source when draining the remaining
Part 2 : Installation

6
water.
7. If the gallon is empty, turn off the red switch
(heater) before replacing it with a new one.
Attention!
⚫This appliance is designed for indoor use.
⚫Avoid placing the appliance in a humid, wet, and poor electrical installation
because it can cause an electric shock or fire.
⚫Do not place flammable objects near the dispenser.
⚫Do not expose the appliance to direct sunlight and rain because it can degrade
its performance and cause electrical leakage hazard.
⚫Do not connect this dispenser to the source of electric current or pressing the
heating button if there is no water in the tank or no water flows from the hot water
tap if the button is pressed.
⚫Do not modify the power cord on the appliance or connect using extension cord
to prevent risks of short circuit and fire.
⚫Do not touch the back or the condenser to avoid electric shock.
⚫During a power outage, after the power returns, wait around 5 minutes before
turning the appliance on.

7
1. Lock/Unlock Button
2. Hot water button
3. Normal water button
4. Cold water button
Hot Water Operation steps:
1. Press the lock button with your finger for three seconds.
2. A beep sound will be heard. Press the hot water button immediately with your
finger. This time, hot water will dispense.
3. When the cup is already filled in with the water, release the button to stop the
water from dispensing. The safety lock will return to the locked state.
Cold Water Operation steps:
1. Press the lock button with your finger for three seconds.
2. A beep sound will be heard. Press the cold water button immediately with your
finger. This time, cold water will dispense.
3. When the cup is already filled in with the water, release the button to stop the
water from dispensing. The safety lock will return to the locked state.
Part 3 : How to Use

8
Normal water does not need to be unlocked. What you need to do is just press and
hold the normal water button and the machine will pump water directly from the tank.
When the cup is already filled in with the water, release the button to stop the water
from dispensing.
Attention!
⚫Beware! Avoid hazard of hot water.
⚫Cabinet door should always be closed.
⚫Do not allow the children dispense the water without direct adult supervision.
1. In order to avoid unwanted incidents, always disconnect the power cord from the
power source before cleaning the dispenser.
2. This dispenser has been disinfected prior to shipping.
3. Water pipe, water tank, and heating element must be cleaned by expert
technician once a year to maintain its good condition and to extend appliance’s
lifespan. Do not attempt to disassemble the machine in order to avoid damage to
the machine.
4. Use soft and wet cloth to clean the surface of the dispenser. Use soft and dry
cloth to dry the surface. Do not let water enter the appliance’s engine.
5. Make sure the power cord is unplugged from the power source when draining
the remaining water or when in a maintenance or when not in use for a long
time. Meanwhile, when the water from the hot tap is cold, open the drain valve
until there is no water in the appliance.
Part 4 : Maintenance

9
a. Install the dispenser on even surface. Avoid placing it in a
humid place. A minimum distance of 20 cm from the wall
must be provided. Do not store flammable substances near
the dispenser.
b. To avoid damage to the machine, avoid connecting power
cord or pressing the heating switch (red) until the hot water
comes out of the hot water tap.
c. If the dispenser won’t be used for a long period, turn off the
heating and cooling switches and disconnect the cord from
the power socket and drain the remaining water through the
drainage.
d. Do not use chemical substances or directly pour water to
clean the dispenser. Use soft cloth instead.
e. Do not pull the cord to disconnect the power cord from the
power socket. Hold and unplug it from the head with dry
hand.
f. Do not put the dispenser upside down. The inclination should
not be more than 45° to avoid damage to the compressor.
Part 5 : Precaution Action

10
g. The thermostat on the dispenser has been adjusted by the
manufacturer. Do not attempt to modify the thermostat by
yourself to avoid unwanted damage.
h. This appliance is designed for use by adults. Do not allow
children to play with the appliance or let them hang on the
door. The appliance may fall over and harm them. Children
should be supervised to ensure that they don’t play with the
appliance. The appliance is not intended for use by individual
(including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
the use of the appliance by a person who is responsible for
their safety.
If there is damage to the power cord, contact MODENA
Call Center immediately to do a replacement. The
replacement of power cord must be done by
experienced expert and understands about electricity.
Never replace the power cord on your own, due to the dangers that could lead
to harm yourself and others.
Attention!
This appliance must not be disposed of with other household waste. To
prevent possible harm to the environment or human health from uncontrolled
waste disposal. The appliance contains a gas insulation and refrigerant that must be
disposed of properly. When you want to dispose of the appliance, We advise you to
consult with authorized service providers so that they can learn information required
and official forms. Make sure the pipes and the duct work of refrigerant of the
appliance is not damaged before it was taken by the disposal personnel. Consult
with authorized service providers to ask everything and issues regarding the