Modena Sottile Series Owner's manual

User
Manual Book
Water Dispenser
Sottile Series
DD 0310

2
Thank you for your trust in choosing MODENA products for your household
needs. With your satisfaction as our priority, we constantly aim to deliver
stylishly designed products equipped with state-of-the-art technology to
assist you in your daily activities.
This is your guidebook containing everything you need to know about our
product. Please reach out to us if you need further assistance or other
information via our Customer Care or our official website www.modena.com.

3
CONTENTS PAGE.
• Introduction 2
• Part 1 : Name of Parts 4
•Part 2 : Installation 5
• Part 3 : How to Use 5
• Part 4 : Maintenance 5
• Part 5 : Precaution Action 6
• Part 6 : Troubleshooting 7
• Part 7 : Specification 8

4
DD 0310
Note :
Part 1 : Name of Parts
1. Bottle supporter 7. Tap of normal water
2. Power switch 8. Tap of hot water
3. Indicator lights 9. Drip tray
4. Name plat 10 Power cord
5. Safety button 11 Drain valve
6. Tap of cold water

5
1. Place the dispenser in a flat and stable surface.
2. Install the gallon in a proper position.
3. Press the hot water button (red) until the water dispense out of the
faucet.
4. Connect the power cord into a power socket. Turn on the red
switch (heating) located at the rear of the appliance.
5. When the water in gallon is up, turn off the switch red (heating)
before replacing it with a new one.
Attention :
-Do not connect the dispenser to the power source nor switch the red switch (heater) if
there’s no water in the tank or if water is not flowing from the hot water tap (red) when the
button is pressed.
How to use a dispenser with three taps:
•To dispense the hot water, push the left button.
•To dispense the normal-temperature water, push the middle button.
•To dispense the cold water, push the right button.
The appliance is equipped with a safety on hot water button to prevent the danger of the reach of
children.
Attention:
•Beware! Avoid hazard of hot water.
1. In order to avoid unwanted incidents, always disconnect the power cord from the power source
before cleaning the dispenser.
2. This dispenser has been disinfected prior to shipping.
3. Water pipe, water tank, and heating element must be cleaned by expert technician once a year to
maintain the machine to its good condition and to extend the appliance’s lifespan. Do not attempt
to disassemble the machine in order to avoid damage to the machine.
4. Use soft and wet cloth to clean the surface of the dispenser. Use soft and dry cloth to dry the
surface. Do not let water enter the appliance’s engine.
5. Make sure the power cord is unplugged from the power source when draining the remaining water
or when in a maintenance or when not in use for a long time. Meanwhile, when the hot water from
the hot tap is, open the drain valve until there is no water in the appliance.
Part 4 : Maintenance
Part 3 : How to Use
Part 2 : Installation

6
1. Install the dispenser on even surface. Avoid placing it in a humid place. A
minimum distance of 20 cm from the wall must be provided. Do not store
flammable substances near the dispenser.
2. To avoid damage to the machine, avoid connecting power cord or
pressing the heating switch (red) until the hot water comes out of the hot
water tap.
3. If the dispenser won’t be used for a long period, turn off the heating and
cooling switches and disconnect the cord from the power socket and
drain the remaining water through the drainage.
4. Do not use chemical substances or directly pour water to clean the
dispenser. Use soft cloth instead.
5. Do not pull the cord to disconnect the power cord from the power socket.
Hold and unplug it from the head with dry hand.
6. Do not put the dispenser upside down. The inclination should not be
more than 45° to avoid damage to the compressor.
7. The thermostat on the dispenser has been adjusted by the manufacturer.
Do not attempt to modify the thermostat by yourself to avoid unwanted
damage.
Part 5 : Precaution Action

7
8. This appliance is designed for use by adults. Do not allow children to
play with the appliance or let them hang on the door. The appliance may
fall over and harm them. The appliance is not intended for use by
individual (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a
person who is responsible for their safety.
If there is damage to the power cord, contact MODENA Call Center
immediately to do a replacement. The replacement of power cord
must be done by experienced expert and understands about
electricity. Never replace the power cord on your own, due to the
dangers that could lead to harm yourself and others.
Attention!
This appliance must not be disposed of with other household waste. To prevent possible
harm to the environment or human health from uncontrolled waste disposal.
The appliance contains a gas insulation and refrigerant that must be disposed of properly. When you
want to dispose of the appliance, We advise you to consult with authorized service providers so that
they can learn information required and official forms. Make sure the pipes and duct work of
refrigerant of the appliance is not damaged before it was taken by the disposal personnel. Consult
with authorized service providers to everything and issues regarding the appliance. Do not do or allow
others to do anything to the appliance before asking the official service providers.
Please check these following before contacting the Call Center if any problem occurs:
Problem
Possible Cause
Recommended Action
Water is not hot or not cold.
-Excessive usage of hot
water or cold water in a
short period of time.
-The appliance is not yet
connected to the power
source.
-Wait until the water
becomes cold or hot.
-Connect the cord to the
power socket and press
the heating and cooling
switches.
Water is not being
dispensed out of the tap.
-Water gallon is empty.
-Replace the water gallon
with a new one
Leak on the water gallon
support.
-Water gallon is leaking /
damaged.
-Replace water gallon with
a new one.
Loud noise during operation.
-Improper installation or
placement of the
appliance.
-Install the appliance on
even and stable surface.
Part 6 : Troubleshooting

8
MODEL
DD 0310
Type
Cold, Hot & Normal
Lower chamber
No
Color
White
Hot water output (liter/hour)
2
Cold water output(liter/hour)
2
High temperature (Celsius)
≥90
Cold temperature (Celsius)
≤10
Free-CFC compressor
Yes
Regulator of thermostat
Yes
Water tube material
Stainless
Heating Power (watt)
190
Compressor power (watt)
90
Product Dimension (L x W x H) mm
260 x 330 x 1010
Product weight (Kg)
10.9
* Specifications of this appliance may change without prior notice to improve the quality of the product.
Pictures in this manual are schematic and may be different from the actual product. Values stated on the machine
labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant
standards. Depending on operational and environmental conditions of the appliance, values may vary.
Part 7 : Specification

11/20