1. Install the dispenser on a flat and stable surface.
2. Install the water gallon in the correct position
3. Press the water tap button / tap (red) until water runs out from the
tap.
4. Connect the electrical cord into the electrical socket, and turn on
the red switch (heater) on the back of the unit.
5. If the gallon is empty, turn off the red switch (heater) before
replacing it with a new gallon
Attention :
-Do not connect the dispenser to a socket nor switch the red switch (heater) if there’s no
water in the tank or if the water is not running from the hot water tap (red) when the tap is
used.
How to use a dispenser with three taps:
•To dispense hot water, push the left button / tap.
•To dispense normal-temperature water, push the central button / tap.
•To dispense cold water, push the right button / tap.
How to use refrigerator (for Dispenser with built-in refrigerator):
-Do not store food / drink in the first usage until the dispenser has been used for 2 hours.
-Hot food must be cooled down to room temperature before stored in the refrigerator.
-Provide adequate space in the refrigerator to make sure the air is circulating well.
How to use sterilization cabinet (for Dispenser with sterilizer room):
-Store food or kitchen utensils to be sterilized inside the cabinet and close the door.
-Turn the timer knob to set the period of sterilization.
-5 - 10 minutes : to retain freshness.
-15 minutes : to sterilize.
-Do not open the cabinet door during the sterilization process to prevent the discharge of O3.
-When sterilization is complete, the timer will automatically return to OFF position.
-Remove food or kitchen utensils after one hour of sterilization.
