Modena Salutare Series Owner's manual

User
Manual Book
Water Dispenser
Salutare Series
DD 7181 L
Vittore Series
DD 67 S
Dentro Series
DD 7302 L

1
Thank you for your trust in choosing MODENA products for your household
needs. With your satisfaction as our priority, we constantly aim to deliver
stylishly designed products equipped with state-of-the-art technology to
assist you in your daily activities.
This is your guidebook containing everything you need to know about our
product. Please reach out to us if you need further assistance or other
information via our Customer Care or our official website www.modena.com.

2
CONTENTS PAGE.
• Introduction 1
• Part 1 : Name of Parts 3
•Part 2 : Installation 4
• Part 3 : How to Use 4
• Part 4 : Maintenance 5
• Part 5 : Precaution Action 5
• Part 6 : Problem & Solution 7
• Part 7 : Specification 8

3
* Features depend on the type of product.
Remark:
1. Power indicator 6. Water tray 11. Power cord
2. Heating indicator 7. Door 12. Tank drain valve
3. Cooling indicator 8. Salver
4. Water shortage indicator 9. Cooling switch
5. Tap 10. Heating switch
Part 1: Name of Parts

4
Please read this manual carefully before operating the unit for proper and safe usage. Examine the
entire sign or warning listed on the pictures or written explanation.
1. Install the dispenser on a flat and stable surface. Provide a
minimum of 20 cm distance from the wall.
2. Leave it for 1 hour to stabilize the refrigerant.
3. Insert the pipe into the gallon and then place the cover into the
mouth of the gallon.
4. Place the gallon inside the cabinet and close the lower cabinet
door.
5. Connect the electrical cord to the power socket, and turn on the
red switch (heater) located behind the unit. Ensure that the
socket/electric source has a grounding to prevent electric
leakage. Then, turn on the switch located behind the unit.
6. For first time usage, the inside of the unit must be cleaned.
Press the hot water and cold water button. Make sure the
water comes out from both taps. After the water comes out
from both taps, wait for 20 minutes, then remove the gallon
from the cabinet storage and empty the water in the unit by
opening the drain cover. Make sure the power cord is
unplugged from the power socket when draining the water.
Attention :
-This unit is designed for indoor use.
-Make sure the pipes are installed properly and the cabinet door is
tightly closed.
-When the water in the gallon is empty, turn off the red switch (heating) before replacing it with a
new one.
-Avoid placing the appliance in a humid, wet, and poor electrical installation because it may cause
an electric shock or fire outbreaks.
-Do not place flammable objects near the dispenser.
-Do not put the appliance in direct sunlight and rain because it can degrade the performance and
cause an electrical leakage hazard.
-Do not connect this dispenser to electric source or pressing the heater if there is no water in the
tank or no water flows from the hot water tap when the button is pressed.
-Do not modify the power cord of the unit or connect using an extension of electricity to prevent a
short circuit and fire hazard.
-Do not touch the back of the condenser to avoid shocks.
How to use a dispenser with three taps:
-To dispense hot water, push the left button / tap.
-To dispense normal-temperature water, push the central button / tap.
-To dispense cold water, push the right button / tap.
This unit features a safety on hot water button to keep hazards out of the reach of children. Scroll and
press the button to dispense hot water.
Part 2: Installation
Part 3: How to Use

5
Attention:
-Avoid exposure to hot water.
-Cabinet doors should always be closed.
-Buzzer or alarm will rings when the water in the gallon is empty and the water shortage indicator
will lights up.
1. To avoid unwanted incidents, always disconnect the appliance from electrical sources before
cleaning the dispenser.
2. This dispenser has been disinfected before shipped.
3. Clean the bottle support, water tube, and heating element by an expert technician once a year to
ensure the machine maintains good condition and extend the usage. Do not disassemble the
machine to avoid damage to the machine.
4. Use a soft and slightly wet cloth to clean the surface of dispenser, and use a soft and dry cloth to
wipe the surface. Do not let the water get into the engine.
5. Make sure the power cord is unplugged from the power socket when disposing of the residual water
or during maintenance or unit is not being used for a long time. Meanwhile, when the hot water tap
dispense cold water, open the drain valve until there is no water left in the unit.
1. Place the dispenser on an even surface. Avoid placing it in a humid place.
Provide a minimum of 20 cm distance from the wall and do not store
flammable substances near the dispenser.
2. To avoid damaging the machine, do not connect the electrical cord or
pressing hot water switch (red) until the water can flow out from the hot
water tap without obstruction.
3. If the dispenser won’t be used for a long period, turn off the heater and
cooler switches and disconnect the cord from the electrical socket and
drain the water through the drainage.
Part 4: Maintenance
Part 5: Precaution Action

6
4. Do not use chemical substances or spray the water directly to clean the
dispenser. Use soft cloth instead.
5. Do not pull the cord to disconnect the plug from the socket. Pull the plug
with dry hand.
6. Do not put the dispenser horizontally. The slope should not exceed 45° to
avoid damage to the compressor.
7. The thermostat on the dispenser has been adjusted by the manufacturer.
Do not attempt to modify the thermostat to avoid unwanted effect.
8. This product is designed for adults. Do not allow children to play with the
appliance or let them hang on the door. The unit might fall and harm the
children. The product is not intended for use by people (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
If there is damage to the power cord immediately contact the
MODENA call center for replacement. Replacing the power cord
must be done by personnel with experience and understanding of
electricity. Never replace the power cord by yourself, due to the
dangers that could lead to harm to you and the others.
Attention!
This product must not be disposed of with other household waste. To prevent possible harm to
the environment or human health from uncontrolled waste disposal.
The unit contains gas insulation and refrigerant that must be disposed of properly. When you want to
dispose of the product, We advise you to consult with authorized service providers so they can learn
the information required and official forms.
Make sure the refrigerant pipes and ductwork in the unit is not damaged before taken by the used goods
handling department.
Consult with authorized service providers to ask all the things and issues related to the units. Do not do
things or allow others to do things to the unit before asking the official service providers.

7
Please inspect the following before contacting the Call Center in the event of operational disturbance:
Problem
Cause
Solution
Water is not hot nor cold.
-Excessive dispensation of
hot water or cold water in
a short period of time.
-Unit is not yet connected
to electricity.
-Wait until the water
becomes cold or hot.
-Connect the cord to the
socket and press the
heater and cooler switches.
Water is not being dispensed
out of the tap.
-Water gallon is empty.
-The pipe is stuck or
clogged.
-Replace the water gallon
with a new one
-Turn off the cooling switch
for 4 hours, and then turn
the switch back.
Leak on the water gallon
support.
-Water gallon is leaking /
damaged.
-Replace water gallon with a
new one.
Loud noise during operation.
-Improper installation or
placement of unit.
-Install unit on even and
stable surface.
Part 6: Problem & Solution

8
MODEL
DD 7181 L
DD 67 S
DD 7302 L
Type
Cold, Hot & Normal
Cold, Hot & Normal
Cold, Hot & Normal
Lower chamber
Gallon storage
Gallon storage
Gallon storage
Color
Black
Black –Stainless
steel
Black
Hot water output
(liter/hour)
5
5
2
Cold water
output(liter/hour)
2
2
2.5
High temperature
(Celsius)
≥90
≥90
≥90
Cold temperature
(Celsius)
≤10
≤10
≤10
Free-CFC compressor
Yes
Yes
Yes
Regulator of thermostat
Yes
Yes
Yes
Water tube material
Stainless
SUS 304
SUS 304
Heating Power (watt)
420
420
420
Compressor power (watt)
100
100
100
Product Dimension (W x
D x H) mm
338 x 360 x 1065
338 x 360 x 1065
372 x 407 x 1145
Product weight (Kg)
19
14.9
18
* The specifications of this appliance may change without notice to improve the quality of the product.
The pictures in this manual are schematic and may not exactly match your product. Values stated on the machine
labels or in the documentation accompanying it are obtained in laboratory in accordance with the relevant
standards. Depending on operational and environmental conditions of the appliance, values may vary
Part 7: Specification

11/20