Nav TV Genesis VIM XG User manual

BHM
05/15/14
NTV-DOC145
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
1 | P a g e
3950 NW 120th Ave, Coral Springs, FL 33065 TEL [phone] FAX [phone]
www.nav-tv.com i[email protected]m
Genesis VIM XG
NTV-KIT278
Overview
The Genesis VIM XG kit adds video in motion to ’09-’12 Hyundai Genesis Sedan and Coupe
vehicles.
Kit Contents
Genesis VIM module
NTV-ASY171
CAN Adapter Harness
NTV-HAR058
Plug & Play T-Harness
NTV-HAR116
USB Cable
NTV-CAB009
.

BHM
05/15/14
NTV-DOC145
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
2 | P a g e
Installation
1. Using a plastic pry tool remove
the bezel from around the DVD
player to expose DVD/Radio
tuner.
2. Lay down a cloth or a towel on
center console as to not scratch
the console when the radio is
removed.
3. Remove (4) Phillips head screws
from all (4) corners and (2) 10mm
nuts from both sides.
4. While holding down the brake
pedal,
Shift vehicle into Drive to remove
radio. Pull radio straight out.
5. Remove factory wire harness
from behind radio.
6. Remove the factory fiber optic clip from factory 44-
pin harness connector.
7. Insert the fiber optic clip into the male end of the
provided T-harness.
Plug &
Play T-
Harness
Insert
factory
fiber

BHM
05/15/14
NTV-DOC145
Agreement: End user agrees to use this product in compliance with all State and Federal laws. NAV-TV Corp. would not be held liable for
misuse of its product. If you do not agree, please discontinue use immediately and return product to place of purchase. This product is
intended for off-road use and passenger entertainment only.
3 | P a g e
8. Connect the white, 8-pin plug from the CAN adapter harness to the
similar plug located in the Plug & Play T-Harness.
9. Connect the interface module to the 18-pin plug
on the CAN adapter harness and mount behind
radio/dash. (all other wires are not used).
10. Plug the factory 44-pin plug into the female end of
the provided T-harness and connect the male end of the T-harness into the radio.
11. Reinstall the radio in reverse order.
Operation
Press the Voice Command button on the steering wheel for 3 seconds to enable/disable
Video in Motion.
Hold for
3
seconds