Ops-Core MOTO MANDIBLE User manual

FOR SENTRY HELMETS
CLEANING & CARE
MOTO MANDIBLE OPERATOR’S MANUAL
© OPS-CORE 2015 UM-1000 REV. B
CLEANING & CARE
•Spot-clean the Moto Mandible with a mild detergent and water.
•Visually check the entire Moto Mandible for signs of breakage.
•Clean dust and dirt by using air pressure.
Check that the ARC Rail clip and straps work properly.
NOTE: IF ANY DEFECTS ARE FOUND, THE DAMAGED COMPONENTS SHOULD BE REPLACED BEFORE USE.

INTRODUCTION
MANDIBLE INSTALLATION
ATTACHMENT
The Moto Mandible quickly attaches to the Sentry Helmet without the use of tools.
INSERT MOUNTING HOOKS
SECURE ARC RAIL CLIPS
MOTO MANDIBLE KIT INCLUDES:
(1) Moto Mandible
ABOUT YOUR MANDIBLE:
This manual covers the installation and basic operating
instructions for the Ops-Core Moto Mandible. The
Moto Mandible provides additional face protection
from blunt trauma and ballistic threats. Insert both the Left and Right Mounting Hooks into the ARC Rail Hook
Receivers as shown. Once both Mounting Hooks are inserted, push down
on the front of the Moto Mandible until the Mounting Shoes are pressed
evenly against the Sentry helmet’s shell edge.
Insert and fasten the ARC Rail Clips
as shown.
NOTE: ADJUST THE LENGTH OF
THE ARC RAIL CLIP STRAP SO
THERE IS NO SLACK AND THAT
IT CREATES A TIGHT, SECURE FIT
FOR THE MANDIBLE.
Left Mounting
Hook
Right Mounting
Hook
ARC
Rail Clip
Mounting
Shoe
Collapses for Easy Storage
Mounting
Shoe
ARC Rail
Hook Receiver