Osram PermaLED® Area Light Medium User manual

PermaLED®Area Light –Medium & Small
INSTALLATION GUIDE
WARNING
!
PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
TO PREVENT PERSONAL INJURY OR PRODUCT DAMAGE ONLY LICENSED ELECTRICIANS SHOULD
PROVIDE ALL INSTALLATION SERVICES.
TO AVOID ELECTRIC SHOCK OR COMPONENT DAMAGE DISCONNECT POWER BEFORE ATTEMPTING
INSTALLATION OR SERVICING.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE NATIONAL ELECTRIC CODE (NEC)
AND ALL APPLICABLE FEDERAL, STATE AND LOCAL ELECTRIC CODES AND SAFETY STANDARDS.
USE CAUTION WHEN HANDLING THIS PRODUCT DURING OR AFTER OPERATION AS IT MAY BECOME
HOT AND CAUSE BURNS. DISCONNECT PRODUCT AND ALLOW COOLING PRIOR TO SERVICING.
ANY ALTERATION OR MODIFICATION OF THIS PRODUCT IS EXPRESSLY FORBIDDEN AS IT MAY CAUSE
SERIOUS PERSONAL INJURY, DEATH, PROPERTY DAMAGE AND/OR PRODUCT MALFUNCTION.
TO PREVENT PRODUCT MALFUNCTION AND / OR ELECTRICAL SHOCK THIS PRODUCT MUST BE
PROPERLY GROUNDED.
THIS LUMINAIRE IS DESIGNED TO OPERATE IN AMBIENT TEMPERATURES RANGING FROM -4C TO 4C
THIS PRODUCT IS SUITABLE FOR WET LOCATIONS.
PermaLED Area Light luminaires are environmentally
preferable, LED alternatives to traditional high-intensity
discharge luminaires with up to 450W HID leading to
energy savings of up to 75% compared to HID.
The luminaires are available with 2 integrated control
options of either a standard photosensor or a dual-
technology motion and photocontrol sensor and provides
up to 10kV surge protection for effective suppression of
most transient AC line surges. Luminaires are ETL listed
in the United States and Canada, assembled in the USA
and backed by a 5 year warranty.
www.osram-americas.com

UNPACKING
Thoroughly inspect the fixture for freight damage. Freight damage should be reported to the delivery carrier.
Compare the catalog/model number description on the packing slip with the fixture label to assure that you have
received the correct product.
INSTALLATION
1. Unlatch (4) power supply compartment latches.
Dimensions for Area Light- Small
Dimensions for Area Light- Medium

2. Attach arm to pole using hardware provided thread - through flat
washer and pole and then through mounting arm, flat washer, lock washer and nut. Tighten nuts to 236 in-
lbs.
3. Attach arm to fixture using hardware provided  bolts and rubber sealing
washers through mounting holes near rear wiring entrance. Thread bolts through sealing washer
and then through fixture mounting holes as shown below. Then thread arm over bolts and add sealing
washer, lock washer and nut. Tighten nuts to 236 in-lbs.
Square pole
assembly
(Note: also
assembles to
round pole)

Arm attachment to fixture (round arm, square arm or horizontal tenon)
4. Re-latch power supply compartment latches.
5. Connect supply leads to 14 AWG stranded wiring cable provided.
6. Attach arm cover using screws provided.
Pole template: Mounting hole dimensions
1 ½

1 ¼ 
5/8

Horizontal Tenon Drawing: Exploded view
Note: Mounts to 1 ¼ - 2” horizontal tenon

WIRING DIAGRAMS
Area Light- No integrated Controls
Area Light- Integrated Controls

Area Light- With Photocell Receptacle
CLEANING AND MAINTENANCE
To maintain the fixture efficacy, an occasional cleaning of the outer lens surface may be needed
Use a mild soap or detergent, which is essentially neutral pH, nonabrasive, and which contains no
chlorinated or aromatic hydrocarbons.
Wash thoroughly, using a soft cloth
Rinse with clean, cold water and wipe dry
WARNING
!Risk of electric shock
Disconnect power before servicing