Overland Storage NEO 200S User manual

10400372-001 03/2012 ©2012 Overland Storage, Inc. Page 1 of 2
*10400372001*
NEO®200s/400s
Spare Power Supply Instructions
This document describes how to remove and replace a power
supply module in a NEO 200s/400s library from Overland
Storage.
WARNING: To reduce the risk of electric shock or damage to
equipment, always remove any power cords while working
with the unit.
AVERTISSEMENT: Pour réduire le risque de choc électrique ou
endommagement de l'équipement, retirez toujours les cordons
électriques en travaillant avec l'appareil.
CAUTION: While working with the unit, observe standard
Electrostatic Discharge (ESD) precautions to prevent damage
to micro-circuitry or static-sensitive devices.
Remove Old Power Supply
1. Power OFF the library by pressing and holding down the
power button on the front for four seconds.
2. Disconnect any power cords from the electrical source,
then from the library.
3. Loosen the three blue captive thumbscrews on the
defective power supply.
4. Pull on two of the thumbscrews to pull the unit away from
the rear panel of the library, then grasp the top and
bottom edge of the power supply and pull it out of the
library.
Install New Power Supply
1. Grasp the top and bottom edge of the power supply and
push it into the empty bay in the library.
2. Tighten the three blue captive thumbscrews () on
the power supply to secure it.
3. Connect all the power cords to the library (), then to
the electrical source.

10400372-001 03/2012 ©2012 Overland Storage, Inc. Page 2 of 2
http://support.overlandstorage.com
You can get additional technical support on the Internet at the Overland Storage Support web page, or by contacting Overland Storage using
the information found on the Contact Us page on our web site.
Spare Power Supply Instructions
Complete the Exchange
Validate the System
1. Power ON the library using the power button () on the
front panel.
2. From the Operator Control Panel (), run the Library
Verify test. (Service > Library Verify).
The verify test requires the use of a scratch (blank)
cartridge. Insert it using the Mail Slot.
3. Do one of the following:
•If the test passes, remove the cartridge, Cancel to exit
Library Verify, and resume normal operations.
•If the test fails, an error code will be displayed. Make
note of the error, then refer to the Troubleshooting
chapter in the NEO 200s/400s User Guide for
additional instructions.
Return Old Part to Overland
For return shipping details and RMA number, go to:
http://docs.overlandstorage.com/return-instructions
1. Place the old part in the anti-static bag and put it in the
replacement part’s box.
2. Use a return merchandise authorization (RMA) number to
return the part to Overland Storage.