Panasonic AK-HCU931 User manual

Installing this unit in the camera control unit
1Remove the blank panel from the connector section of the AK-HCU931P.
2Insert this unit and tighten the screws removed in step 1.
720P Output Port Unit
Model No. AK-HHD931P
Printed in Japan
VQT0B71 F0902H0-5@3
PUSH
SD
RET1
SDI INPUT SDI OUTPUT
RET2 RET1 RET2
PROMPT
RET3 RET4 OUT1 OUT2 OUT3 OUT4
SD
COMMUNICATION
WFM1
IN RTS
OUTCH–1CH–2
DIGITALAUDIO
TRUNKWFMCONTROL
AUXROP
CSU/ MSU
ALARM
GND
MIC OUT
WFM2PM1 PM2VBS1 VBS2 HD HD REFSD
SD
OUTPUT
INPUT 12
SYNC OUTPUT
SD REF
ACIN
PUSH
HD
RET1
SDI INPUT SDI OUTPUT
RET2 RET3 RET4 OUT1 OUT2 OUT3
OUT4/PM Y / G Pb / B Pr / R PM
HD
OUTPUT
SD
RET1
SDI INPUT SDI OUTPUT
RET2 RET1 RET2
PROMPT
RET3 RET4 OUT1 OUT2 OUT3 OUT4
SD
COMMUNICATION
WFM1
IN RTS
OUTCH–1CH–2
DIGITALAUDIO
TRUNKWFMCONTROL
AUXROP
CSU/ MSU
ALARM
GND
MIC OUT
WFM2PM1PM
2VBS1 VBS2 HD HD REFSD
SD
OUTPUT
INPUT 12
SYNC OUTPUT
SD REF
ACIN
Remove these screws.
Tighten the screws.
CAUTION:
These servicing instructions are for use by qualified service personnel only. To
reduce the risk of electric shock do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so.