
EN11
English
Circuit Breaker Protection
When the Circuit Breaker automatically stops the motor due to overloading, follow the below steps:
1Switch off to reset the Circuit Breaker.
2Reduce the ingredients to less than 1/2 of the working capacity and/or remove hard ingredients.
3Resume blending. If the Circuit Breaker still activates, repeat step 1 - 2. Do not repeatedly reset the Circuit
Breaker.
Note:
• Circuit breaker may not reset over 40 °C room temperature. In that case please move appliance to the room
temperature under 35 °C and wait until it is cooled down.
Troubleshooting
Ensure to turn OFF the appliance and the power supply before taking the actions in the table below
Problems Causes Actions
The appliance does not turn on. The Plug is not inserted to the root of the power
source.
Insert the Plug down to the root.
Even though the power is on, the
appliance does not start blending.
The Blender Jug or the Mill Container is not placed
correctly.
Place the Blender Jug or the Mill Container correctly.
Overloaded with ingredients or prohibited ingredients
are used.
Do not exceed the working capacity of the ingredients and
ensure that prohibited ingredients are not used.
The Safety Lever is stucked. Disassemble the Blender Jug Base and follow the
assembly sequence (page EN5).
The appliance stops during
blending.
The Circuit Breaker protection is activated.
•
Too many ingredients or hard ingredients are used.
See "Circuit Breaker Protection".
Prohibited ingredients are used. Remove prohibited ingredients.
Maximum operating time is exceeded. Turn off the power and refer to the recommended operating
time (page EN3).
The mixture in the Blender Jug is
leaking.
The Blender Jug Base is attached loosely. Tighten the Blender Jug Base firmly onto the Blender Jug.
The Blender Gasket is not installed correctly. Install the Blender Gasket correctly.
The Blender Gasket is not installed. Install the Blender Gasket.
The Safety Lever is stucked. Disassemble the Blender Jug Base and follow the
assembly sequence (page EN5).
There is abnormal noise or
vibration.
Too many ingredients in the Blender Jug. Turn off the appliance and reduce the ingredients.
The Blender Jug Base is attached loosely. Tighten the Blender Jug Base firmly onto the Blender Jug.
The Cutting Blades is spinning
freely without cutting.
Ingredients are stuck to the wall of the Blender Jug. Turn off the appliance and insert the Scraper to circulate.
Quantity of the liquid is low. Add liquid.
• A "kiiiiin" sound may be heard during operation. This is normal.
Specifications
Function Blender Dry Mill
Power Supply 220 - 240 V
50 - 60 Hz
Power Consumption 290 - 320 W
Switch (OFF), 1, 2, P1, P2
Operation Rating 2 minutes ON
2 minutes OFF
1 minute ON
2 minutes OFF
Dimension (Approx.)
W × L × H (mm) 188 x 210 x 405 170 × 210 × 262
Mass (Approx.) (kg)3.6 2.1
Working Capacity
(Approx.) 1.5 L 50 g(Coffee Beans)
Cutting Blades 4 stainless steel blades 2 stainless steel blades