
The mxiture is
leaking.
▶
●The tumbler unit is not assembled firmly.
➡Assemble it firmly. (P. EN8)
●
The lid gasket or tumbler base gasket is not attached
firmly.
➡Attach it them properly.
●Foreign matters are adhered around the lid gasket or
tumbler base gasket.
➡Remove the foreign matters.
●The tumbler base gasket is damaged.
➡Replace it.
Problem Cause and Action
●
Lubrication oil might be traced around the upper connector (P.EN7) but it will not
affect the performance. Wipe them off with kitchen paper.
●
"Peep"soundmaybeheardduringoperation,butitisnotabnormal.
Overloading Protection
Inthecaseofoverload,theprotectiondeviceistriggeredtostopoperationandit
is not abnormal. After rotation stops, take the following steps.
●
Do not operate the appliance repeatedly without any countermeasure. (Cause of
smoking, unpleasant smell or malfunction)
(
Contact Service Centre for inspection or repair if it still does not operate normally.
)
Twisttumblerbackto"OFF"direction,
remove it from motor housing.
Reduce the ingredients in tumbler to half
●Remove the prohibited ingredients if it is used.
●
When the blade is stuck with ice cubes, remove it from the tumbler,
for the caught one around the blade, remove it by flushing water.
●
For smoothie etc. with high viscosity or low moisture, reduce the
ingredients and add more liquid.
●Rest the appliance for more than 1 minute.
Reset the tumbler, start blending again.
1
2
3
Even though
the tumbler is
twisted to
"ON"direction,
the appliance
does not start
blending.
▶
●The tumbler unit is not attached with the motor housing
properly.
➡When attaching it, make sure the mark on tumbler
base and motor housing have been aligned, then twist
itfirmlyuntilyouheara"click"sound.
●The tumbler base is not attached tightly.
➡Assemble it tightly.
●The power plug is disconnected.
➡Insertthepowerplugintooutletfirmly.
●Ingredientsarestuckaroundtheblade.
➡Remove all ingredients and then replace them.
The blade is
Idling.
▶
●The liquid amount is not enough.
➡Add more liquid.
●Too much ice cubes.
(e.g.juicewithalotofice)
➡①Twistthetumblerbackto"OFF"direction,remove
tumbler after rotation stop completely.
②Shake the tumbler gently.
•Ifithappensagain,reducetheingredients.
The appliance
stops during
blending.
▶
●The overloading protection device is activated.
•
Prohibited ingredients are added.
•
Too much ingredients are used.
•
Ingredientsaretoolarge.
•
Ingredientsaretoohard.(e.g.shavedice)
•
There is abnormal noise or vibration is too large.
➡
Referto“OverloadingProtection”forinspection.(P.EN15)
Ifprohibitedingredientsareused,removethem.
There is
abnormal
noise or
vibration.
▶
●Too much ingredients.
➡
Twisttumblerto"OFF"directionandreduceingredientamount.
●The tumbler unit is not assembled firmly.
➡Assemble it firmly. (P. EN8)
EN15