Panasonic KX-T336 User manual

STOP!!!
READ THIS FIRST I
Before upgrading the KX-T336 to the 12.00 revision that is included with this kit be
sure to read and understand the WP (version up ) command that is detailed on I
additional page 15-G-3.
This command is used to initialize the RAM area of the newly added system memory while
keeping the current settings intact.
Technical Manuals Online! - http://www.tech-man.com

.,
1NSTAf;wLTION INSTRUCTIONS FOR W-T336 EPROMS
mt The following procedures should be followed in the exact
order in which they are written. If these instructions are not
followed, permanent damage to the RMSS could result.
NOTR: It is recommended that before upgrading the EMUS that all
programming be saved (section 16) since the system may return to
the default program during this procedure.
Materials needed to complete this software change:
4 l Eprom(s) -
1 l IC extraction tool
.
1)
2)
3)
4)
5)
6) .
‘1
8)
9)
10)
11)
12)
13)
14)
1%
16)
17)
Turn the power switch on all KX-T336 cabinets to the OPF
position and disconnect all power cords
from the AC
If any optional system battery adapters (RX-A26) are outlets.
installed, set their power switches to the off position.
Remove the front cwer by turnin
then pulling the cover
forward.
g the key counterclockwise and
Locate the aCPUa card installed in slot BS 1 and remove the
guide plate from the upper front side (if installed) to allow -
access to the TPU” card.
Set the 'W&e" switch on the "CPU" card to position 0 and set
the "synm" switch to 0.
Before removing the-"CPU",
be sure to be wearing an anti-
static wristband or to ground yourself.
Remove the
"CPU" card which is inserted into the slot marked
"CPU* by lifting both latches on the "CPU" card and/z&en
pulling the card out.
Place the
"CPU" card on a flat work surface and locate IC 11,
12., 13 and'14 (see figure 1).
Gently remove the chips from the sockets using a IC
extraction tool.
Install each new IC in the proper socket on the *CPU" card
making sure that they are in the correct position and that
all the pins remain straight.
Install the "CPU" card.
Install the PCB guide plate.
Connect all power cords to the AC.outlets.
Turn the power switches to the ON positions and push the reset
button.
Wait until system returns to the on-line mode.
Turn the power switches on all optional system battery
adapters (~~0~26) to the ON position.
Verify that all programming is retained or Load system
parameters as instructed in section 16.
Page 1 of 2
Technical Manuals Online! - http://www.tech-man.com

Supplement Manual for
KX-A220 @ manual
This Supplement Manual is issued to provide
information on new features (described on the
following pages) which have been added to the
KX-T336 System after the KX-A220 @
manual was printed.
KX-A220 @ manual consists of:
.
Vol. 1 (PQQX6483XA)
Vol. 2 (PQQX6485XA)
Technical Manuals Online! - http://www.tech-man.com

Notice
The KX-T336100 with the mark @ provides new features as described
below.
Location of the mark @
The mark @ is attached to the back of the unit as shown below.
* New Features
The KX-T336 System provides the following new features that enhance system
operation.
Available from software Version 12.00 (CPU card ROM: Y251L - Y254L) and above.
l Call Forwarding - Follow Me (CFM command)
l DISA/AGC Tone Detection Mode (TDM command)
l Limited Call Duration (LCD command)
l Ringback Tone while Transfer (WS3 command)
l Screened Cal!Transfer to Trunk by SLT (WS3 command)
l Tie Lines
l T-l Interface (KX-T96187)
2
Technical Manuals Online! - http://www.tech-man.com

Please replace the following pages in the old version with newly issued revised version
attached.
Newly issued pages are marked as “(70695)“.
Vol.1
Old Version
Cover Page (Section 1)
l-1 (60395)
1-2
1 -A-l
1 -A-4
1 -A-5 (60395)
1 -A-6
1 -B-l (60395)
l-D-3
1 -E-l (30393)
1 -E-2 (30393)
l-E-3
1 -E-4 (E)
1 -E-5 (60395)
l-E-6 (50195) (E)
1 -E-7
1 -E-8 (50195)
1 -E-9
1-E-10 (E)
l-E-11 (E)
2-2 (60395)
2-A-l
New Version
Cover Page (Section 1)
l-l (70695)M
l-2 (70695)M
l-A-1
l-A-4
1 -A-5 (70695)M
1 -A-6 (70695)M
1 -El (70695)M
l-B-l-1 (70695)M
blank
1 -D-3
1 -E-l (70695)M
1 -E-2 (70695)M
1 -E-3
1 -E-4 (E)
1 -E-5 (70695)M
l-E-6 (70695)(E)M
1 -E-7 (70695)M
1 -E-8 (70695)M
1 -E-9 (70695)M
1 -E-l 0 (70695)(E)M
l-E-11 (70695)(E)M
1 -E-l 2 (70695)M
blank
2-2 (70695)M
2-A-l
3
Technical Manuals Online! - http://www.tech-man.com

Old Version
-
3-2 (60395)
3-3 (60395)
3-B-2
3-B-3 (60395)
3-B-4 (30393)
3-B-5
3-B-7 2
3-B-l 3
3-B-19
3-B-20
New Version
2-C-28-l (70695)M
2-C-28-2 (70695)M
2-C-28-3 (70695)M
2-C-28-4 (70695)M
2-C-28-5 (70695)M
blank
Insert these sheets after
page 2-C-28.
3-2 (70695)M
3-3 (70695)M
3-B-2
3-B-3 (70695)M
3-B-4 (70695)
3-B-4-1 (70695)
blank
3-B-5 (70695) .
3-B-12
3-B-l 3 (70695)
3-B-l 9
3-B-20 (70695)M
4
Technical Manuals Online! - http://www.tech-man.com

Old Version
3-F-66 (40993)
blank
4-2
4-3 (30393)
4-F-18
4-F-l 9
4-F-20
4-G-l
5-2 (30393)
5-A-l (60395)
New Version
3-F-66 (40993)
3-F-67 (70695)M
3-F-68 (70695)
3-F-69 (70695)
3-F-70 (70695)
3-F-71 (70695)M
3-F-72 (70695)
3-F-73 (70695)
3-F-74 (70695)
3-F-75 (70695)
3-F-76 (70695)
3-F-77 (70695)
3-F-78 (70695)
3-F-79 (70695)
3-F-80 (70695)
3-F-81 (70695)
3-F-82 (70695)
3-F-83 (70695)
3-F-84 (70695)M
3-F-85 (70695)M
3-F-86 (70695)M
blank
4-2
4-3 (70695)
4-F- 18 (70695)
4-F-l 9
4-F-20
4-F-21 (70695)
blank
4-G-l
5-2 (70695)
5-A-l (70695)
5
Technical Manuals Online! - http://www.tech-man.com

Old Version
5-D-l
5-D-2
5-D-3 (50195)
5-D-3-l (21292)
5-D-3-Z (40993)
5-D-4 (21292)
5-D-l 5 (21292)
5-D-l 6
-
5-E-l
5-E-2
New Version
5-D-l (70695)
5-D-l -1 (70695)
5-D-2 (70695)
5-D-3 (70695)
5-D-3-l (70695)
5-D-3-2 (70695)
5-D-3-3 (70695)
5-D-4 (70695)
5-D-l 5 (21292)
5-D-l 6 (70695)
5-D-l 9 (70695)
blank
insert this sheet after
page 5-D-l 8.
5-E-l (70695)
5-E-l-l (70695) .
blank
5-E-2 (70695)
.
Technical Manuals Online! - http://www.tech-man.com

Vol.2
Old Version
7-c-3
7-C-4 (60395)
7-C-5 (60395)
7-C-6
8-D-l (50195)
8-D-2
8-G-l (60395)
blank
Cover page (Section 9)
9-1
9-2 (60395)
9-3 (60395)
9-A-l
9-B-l (60395)
9-c-2
9-C-3 (60395)
9-c-4
9-c-5 (30393)
-
9-D-l (60395)
9-D-2 (60395)
9-D-3 (60395)
9-D-4 (60395)
9-D-7
9-D-8 (60395)
9-D-l 7
9-D-l 8 (21292)
9-D-l 9 (30393)
9-D-20
9-D-33
9-D-34
New Version
7-c-3
7-C-4 (70695)M
7-C-5 (70695)M
7-C-6
8-D-l (70695)M
8-D-2
8-G-l (70695)M
blank
Cover page (Section 9)
9-1 (70695)M
9-2 (70695)M
9-3 (70695)M
9-A-l
9-B-l (70695)M
9-c-2
9-C-3 (70695)M
9-C-4 (70695)M
9-C-5 (70695)
9-C-8 (70695)
blank
Insert this sheet after
page 9-C-7.
9-D-l (70695)M
9-D-2 (60395)M
9-D-3 (7069’5)M
9-D-4 (70695)M
9-D-7
9-D-8 (70695)M
9-D-l 7
9-D-l 8 (70695)M
9-D-19 (70695)M
9-D-20 (70695)M
9-D-33 (70695)
9-D-34 (70695)
7
Technical Manuals Online! - http://www.tech-man.com

Old Version New Version
9-D-35 9-D-35 (70695)
9-D-36 (30393)
I
9-D-36 (70695)
I
9-D-37 (60395) 9-D-37 (70695)M
9-D-38 9-D-38 (70695)
9-D-39 9-D-39 (70695)
9-D-40 9-D-40 (70695)
9-D-41 9-D-4 1 (70695)
9-D-42 9-D-42
f706951
9-D-43 9-D-43 (70695)
9-D-44 9-D-44 (70695)
9-D-45 9-D-45 (70695)
9-D-46 9-D-46 (70695)
9-D-47 9-D-47 (70695)
9-D-48 (E) 9-D-48.(70695)(E)
9-D-49 9-D-49 (70695)
9-D-50 9-D-50 006951.
9-D-51 9-D-51 (70695)
9-D-52 9-D-52 (70695)
9-D-53 9-D-53 (70695)
9-D-54 9-D-54 (70695)
9-D-55 9-D-55 (70695)
9-D-56 (30393) 9-D-56 (70695)
9-D-57 (30393) 9-D-57 (70695)
Ei
9-D-62 (70695)
9-D-63 (30393) 9-D-63 (70695)
9-D-64 (30393)
9-D-64 (70695) .
8
Technical Manuals Online! - http://www.tech-man.com