ParaBody 828104 User manual

828104 FLAT BENCH
ASSEMBLY INSTRUCTIONS
Part # 6797601 1Revision:01/20/00

~ IMPORTANTNOTES!
WELCOME TO THE WORLD OF ~~$
Please note:
* Thankyou for purchasing the Parabody 828104FLATBENCH.
Please read these instructions thorougt~yandkeep. themfor ~:ture ie~er~: Tiffs p~odU~t
mustbe assembledona flat, level surfaceto assureits propelfunction:
* Werecommendcleaning your product (pads and frame) on a regular basis, using warmsoapy
water. Touch-uppaint can be purchasedfromyour Parabodycustomerservice representative
at [phone].
Thereis a risk assumedby individuals whouse this type of equipment.Tominimizerisk, please
followthese rules:
1. Inspect equipmentdaily. Tighten all loose connectionsand replace womparts immediately.
Failure to doso mayresult in serious injury.
2. Donot allow minorsor children to play on or aroundthis equipment.
3. Exercisewithcare to avoidinjury.
4. If unsureof properuse of equipment,call yourlocal Parabodydistributor or call the
Parabodycustomerservice departmentat [phone].
Tools Required for Assembly
I
* 9/16" wrench
* Ratchet with 9/16" socket
*Adjustable wrench
* Tape measure
I Bolt Length Ruler [
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OF THE HEAD OF THE BOLT.
BOLT LENGTH RULER: BOLT LENGTH
1/2 [ 1/2 [ 1/2 [ 1/2 ] 1/2 ] 1/2 [
3
12 ]111 ,l[[,,,],,
I,,[lll]lll I 4 56

KEY
I
2
3
PART#
6589703
6600403
.4
DES~ON
BENCH ~t~
6593202~ " - PAD ASSEMBLY
KEY PART#
53102802
63102904
7, 6467001
¯DI~CRIPTION
3/~ ~" LOCKNUT
3 ’8 X 3" BOLT
2" ,’;Q COVERCAP.
4
6
4
STEP1:
¯ Insert two2" SQ.COVERCAPS(7) into the endsof the TUBE(2) as showninFIGURE
¯SECURELYassemblethetwoTUBES(2) to the BENCHFRAME(1) using four 3/8 X3" BOLTS(6), eight
WASHERS(4), andfour 3/8" LOCKNUTS(5). See FIGURE
3

FIGURE 2
3/8 x
STEP2:
¯ SECURELYassemble the PAD(3) to the BENCHFRAME(1) using two 3/8" X 3" BOLTS(6), two
WASHERS(4). See FIGUKE
THIS CONCLUDESTHE ASSEMBLYOF THE828104 FI.,~kT BENCH
112 I 1/2 [ 1/2 ] 1/2 [ 1/’2 I 1/2 I
56
4