Paradox K641+ User manual

Printed in Canada | 10/2014 K641+ Install Guide
Compatibility
The K641+ is compatible with EVO192 and EVOHD. Please refer to the Technical
Specifications section for more details.
Technical Specifications
Warranty
Warranty: For complete warranty information on this product, please refer to the Limited Warranty Statement
found on the Web site www.paradox.com/terms. Your use of the Paradox product signifies your acceptance of all
warranty terms and conditions.
© 2014 Paradox Ltd. All rights reserved. Specifications may change without prior notice.
www.paradox.com
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
K641+ Keypad
Quick Install Guide
The K641+ keypad allows you to configure your Paradox system through its
interface.
Installation
1. Using a flathead screwdriver, pry the front housing assembly from the
backplate.
Figure 1: Opening the K641+
Operating Voltage 9 to 16Vdc
Operating Temp. -10 to 55°C (14 to 131°F)
Power Consumption Maximum current - 150mA
Dimensions 15 x 12.6 x 2.7 cm (6 x 4.9 x 1.06 in.)
Weight 230g (8.1 oz)
Humidity 5-93%
Compatibility EVO192 v2.16 or higher and EVOHD V1.0 or higher
Compliance EN50131-3 Grade 3; Environmental Class II
K641+-EI01

2. If using surface mounted cabling, you will need to knock out the plastic tab #1
at the top or bottom of the K641+ backplate in order to for the cable to pass
through, refer to figure 3.
3. Insert needle nose pliers into the appropriate plastic tab and carefully break off.
Figure 2: Surface-mount cabling plastic tab removal
4. Mount the backplate to the wall by securing a M3.5 (#6) screw in each of the
dedicated mounting holes and tamper hole while ensuring that the top is up, as
shown in figure 3. For EN installations, use the designated mounting holes (#2).
Figure 3: K641+ Backplate
5. Connect the 4-wire combus wires to the connector bus, as shown.
Figure 4: Wiring
6. Assemble both items by joining the hooks on the backplate to their respected
slots on the front housing assembly.
7. Secure the front housing to the backplate by snapping it into place.
The installation process is now complete.
Configuration
Modules can be configured using this keypad or BabyWare. The preferred option is
to use BabyWare to configure the system.
To configure modules through the keypad
1. Press and hold the 0 (number zero) key.
NOTE: The area must be disarmed to configure modules.
2. Initially you will see User Access Code but within 2 seconds it will change to
Installer Code.
3. When the Installer code appears, input the Installer code number, the default
number is [000000].
4. Input the 4 digit section code for Module Programming [4003].
NOTE: You need module serial numbers for programming.
5. Input the module serial number.
6. Input module section [001].
7. Now you can start module programming.
Cable pass-through
1
1
2 2
2 2
Wall Tamper
Plastic tab
EN mounting holes
Mounting holes
33
33
Note:
ZX1 is a Programmable input
PGM is a Programmable output
All Disarmed
2014/19/05 16:00
User Access Code
[* _ ]
Installers Code
[ _ ]