Philips Pure Taste WP3861 User manual

WP3861

2

33
A
B
D
E
1
23
F
G
4
C
H
I
J
K
L
1

4

WP3861
ENGLISH 6
INDONESIA 16
BAHASA MELAYU 25
 35
繁體中文 44
59
67

6
General description (Fig. 1)
A Non-woven cloth
B Silver-coated granular activated carbon
C Filter cartridge
D Capofltercartridgeholder
E Viewing window
F Filter cartridge holder
G Water selection lever
H Waterpurierhousing
I Stainless steel screen
J Rubber washer
K Adapter
1 A-type
2 B-type
3 C type
4 D-type
L Attachment nut
Important
Read this user manual carefully before you use the appliance and save it
for future reference.
Before daily use
Topreventquickcloggingoftheltercartridge,letthewaterrunat
theunlteredsettingforaround5secondsbeforeeveryuse.
If the water is highly coloured or turbid due to work on your water
network,donotletthewaterrunatthelteredsettinguntilthe
water is clear.
Cautions:
1 Letthewaterrunatthelteredsettingfor10secondsbeforeuse
each day.
2 Letthewaterrunatthelteredsettingfor60secondsbeforeuseif
youhavenotusedthewaterpurierformorethantwodays.
3 Ifyouarenotgoingtousethewaterpurierformorethantwo
weeks,puttheltercartridgeintherefrigeratortoensureitsgood
-
-
-
ENGLISH

performance.Whenyoustartusingthewaterpurieragain,let
thewaterrunatthelteredsettingfor1minutebeforeuse.Ifthe
ltercartridgeemitsanunpleasantsmell,replaceitwithanewone.
Water temperature
Donotletwaterhotterthan65°Crunthroughthewaterpurierat
theunlteredsettingorhotterthan50°Catthelteredsetting.
This may damage the appliance.
Donotletthewaterpurierfreeze.
Applications
Onlyusetheappliancetolterwaterthatmeetsdrinkingwater
standards.
Donotblockthelteredwateroutletorconnectotherdevicestoit.
Ifthewaterpressureisveryhigh,reducethewaterowofthetapto
prevent damage to the cartridge.
Keepthewaterpurierawayfromheattoavoiddistortionor
breakage.
Donottamperwiththewaterpurier.
This appliance does not soften water.
Donotuselteredwaterinaquariums.Tapwater,lteredor
unltered,canbeharmfultosh.
Donotstorepuriedwater.
Domestic appliance for drinkable water treatment.
Features
Thewaterpurierremoveschlorine,unpleasantsmellsandtastes,as
well as large sediments from your tap water.
The silver-coated activated carbon prevents bacteria growth inside
thelter.
The replacement reminder sticker helps you remember when to
replacetheltercartridge.
The2ltrs/minhigh-speedinitialowrategivesyouplentyofclean
water instantly.
Thewaterselectionleveroffersyouachoiceofthreewaterow
types:unlteredspray,unlteredstreamorlteredspray.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
ENGLISH 7

Theeighttap-mountingadapterssuppliedwiththewaterpurier
allow easy installation on almost any type of tap.
Thebayonet-typemountensuresquick,easyandsecurelter
cartridge replacement.
Preparing for use
Before installation
Beforeyouinstallthewaterpurier,makesurealltap-mounting
adapters you require are present.
Thetapmusthaveadiameterof13mm-25mm.
Determine what type of tap you have and select the appropriate
adapter.
Theadapterssuppliedmakethewaterpuriersuitableforalmost
anykitchentap.However,thewaterpuriermaynottsome
uncommon types of taps.
Thetapwaterpressurehastobebetween0.7kgf/cm²(7metresof
watercolumn/70kPa)and3.5kgf/cm²(35metresofwatercolumn/
350kPa).Ifyouusethewaterpurieratawaterpressureoutsidethis
range,eitherthelteredwaterowwillbeextremelyloworthe
waterpurierwillgetdamaged.
Installation A-type adapter
Fortapswitharoundspoutwithadiameterof16mm,17.5mmor
19mm(Fig.2).
1 Remove the attachment nut and the adapter from the water
purier housing (Fig. 3).
2 Pass the attachment nut over the tap spout (Fig. 4).
3 Place the matching adapter (A-type) over the tip of the spout. The
16mm adapter is packed with the water purier. Replace it with
the 17.5mm adapter or 19mm adapter to t the diameter of your
tap (Fig. 5).
4 Screw the attachment nut rmly onto the water purier
housing (Fig. 6).
-
-
-
-
-
-
-
-
ENGLISH8

Installation B-type adapter
Fortapswithanaerator(threadedoutside)(Fig.7).
1 Remove the attachment nut and the adapter from the water
purier (Fig. 8).
2 Remove the aerator cap from the tap and pass the attachment nut
over the spout. Take out the original adapter and screw the
matching adapter (B-type) onto the tap (Fig. 9).
3 Tighten the adapter further with a coin (Fig. 10).
4 Firmly screw the attachment nut onto the water purier
housing (Fig. 11).
Installation C-type adapter
Fortapswithanaerator(threadedinside)(Fig.12).
1 Remove the attachment nut and the adapter from the water
purier housing (Fig. 13).
2 Remove the aerator cap from the tap. Take out the original adapter
and screw the matching adapter (C-type) onto the tap through the
attachment nut. (Fig. 14)
Ifwaterleakageoccurs,windTeontaperoundtheadapter’sthread
before you screw it onto the tap.
3 Tighten the adapter further with a coin (Fig. 15).
4 Firmly screw the attachment nut onto the water purier
housing (Fig. 16).
Installation D-type adapter
FortapsotherthanA,BorC.(Fig.17)
1 Remove the attachment nut and the adapter from the water
purier housing (Fig. 18).
2 Take out the original adapter and screw the D-type adapter onto
the water purier housing. (Fig. 19)
3 Push the water purier housing onto the tap from below and
tighten the 4 screws evenly (Fig. 20).
-
-
-
ENGLISH 9

4 Screw the attachment nut rmly onto the water purier
housing (Fig. 21).
Makesuretherubberwasherisrmlypushedagainstthetaptoprevent
water leakage.
Installing the lter cartridge
1 Make sure the tap is closed.
2 Set the water selection lever to the unltered stream
position (Fig. 22).
3 Tilt the lter cartridge holder 90° backwards and insert it into the
water purier housing (Fig. 23).
4 Pull the cartridge holder upwards until it is in upright
position. (Fig. 24)
Using the appliance
1 Make sure that the water purier housing and the lter cartridge
holder are properly installed.
2 Turn the water selection lever to the desired setting (‘click’).
Filtered spray
Selectthissettingfordrinking,washingvegetablesorfruitsand
for cooking.
Tip: We advise you to boil the ltered water before you drink it.
1 Turn the water selection lever until the ltered spray symbol is
aligned with the indicator (Fig. 25).
Do not let water hotter than 50°C run through the water purier at
this setting, as this may damage the water purier.
If you lter water between 35°C and 50°C, the water may have an
unpleasant smell. The lter cartridge has absorbed this smell during
ltering, but releases it again if you lter water hotter than 35°C.
ENGLISH10