Precor Discovery Series 608 User manual

Discovery™ Series Squat Rack (608) Assembly Guide
To assemble your equipment, follow the steps in the order listed in this assembly guide. For
more product information, visit us at www.precor.com.
WARNING
At least two people are required to assemble the equipment.
DO NOT attempt assembly by yourself.
Assembly requirements
When assembling the equipment, we recommend you:
Unpack the box and assemble the equipment close to where you plan to use it.
Locate the equipment at least 79 inches (2 meters) away from walls or furniture on
either side of the equipment, and 79 inches (2 meters) away from objects behind or in
front of the equipment.
Assemble the unit on a solid, flat surface, so that it remains level and stable.
DO NOT move the equipment without assistance.
Required tools
10 mm hex bit
Specifications
Equipment Dimensions:
67” L x 64” W x 74” H (1705 mm L x 1615 mm W x 1885 mm H)
Equipment Weight:
273 lb (124 kg)
Hardware kit
Component
Quantity
Component
Quantity
Socket head cap bolt (M12 x 35 mm) 8 Hex key (10 mm) 1
Flat washer (13 mm x 26 mm) 8 Storage horn bumper 4
Socket head cap bolt (M12 x 50 mm) 4 Weight storage horn 4
Flat washer (13 mm x 20 mm) 4
Begin assembly
Important
DO NOT fully tighten the fasteners until instructed to do so.
To assemble the Squat Rack:
1. Have your assistants hold the two uprights side by side (Figure 1).
2. Position the base crossbar between the uprights and secure it using four bolts
and four washers .
3. Position the upper crossbar between the uprights and secure it using four bolts
and four washers .
Note
Position upper crossbar so that the Precor name plate faces inward (Figure 1).
4. Fully tighten all bolts.
Figure 1

To attach a long weight storage horn:
1. Insert a long weight horn through the hole in the equipment frame (Figure 2).
2. Secure the weight horn using a bolt and a washer .
3. Push the storage horn bumpers onto the horn with their wide side facing outward.
If needed, use a weight plate to push the bumper against the equipment frame.
4. Repeat this procedure to attach all long weight horns.
Figure 2
Bolt the equipment to the floor
Precor recommends that the strength equipment be bolted down at all anchoring points. Bolting is made
possible by removing the end caps at the frame base and exposing the mounting holes that accommodate the
bolts (see the accompanying figure). Replace end caps when bolting is complete.
Important As floor materials vary, it is important that you consult a licensed contractor to advise you on proper bolting
techniques and appropriate fastener types.
Standards occasionally change or are updated. Precor recommends that you keep apprised of your local industry
standards. Precor shall not be held liable for failure to properly bolt the strength equipment to the floor.
Figure 3
Squat Rack (608) Assembly Guide | P/N CW39240-101 rev B, ENU
©2016 Precor Incorporated | May 2016