ramia HB-CW User manual

A-6pcs B1-4pcs B2-2pcs C-4pcs F-1pc 1pc
10x40 mm 6x30 mm 6x40 mm 5x100 mm
Montážní návod / Assembly Instructions HB-CW
Attention:
Parts
Packing 1
Packing 2
4pcs
ENG
Product ismade of high quality beech wood guaranteeing maximum resistance and long service life of the bench.
Like all solid wood products it must not be left in areas of high humidity or damp that will cause natural movement.
Recommended humidity level max. 60%.
Product has NO TREATMENT.Please treat your the worktop with a varnish or oil before assembly including bottom of worktop.
Don´t forget torepeat surface treatment each 6 months. This isespecially important if situated in an unheated workshop , garage or outbilding.
Varnish (oil) prevents absorption of surrounding moisture.
Wood isa natural product, check and tighten all screws and bolts every 6 monhts.
To increase stability, theworktop can bescrewed to a table.
WARNING!!! - In this case, the table top towhich you will screw the worktop will be damaged!!!
Date
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz

A+F
Front leg with holes for spindle
Tělo vřetene
Spindle "body"
B1
C
Vice jaw
Spindle with guide rods
B2
A+F A+F
Back leg without holes for spindle
Before screwing of vice jaws, be surethat jaw is parallel with worktop .
Hint: Tighten jaws using spindles. Align jaws with bench top and then use B2 screws for attaching jaw tospindles.
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz