ramia PRO-AS1600 User manual

A1-30pcs A2-8pcs B1-4pcs B2-4pcs B3-2pcs B4-3pcs C-4pcs D1-4pcs D2-4pcs E-4pcs F-1pcs G-1pcs
10x40 mm 8x40mm 5x100mm 5x90mm 4x40mm 6x40mm M12x100 M12 M12 M12
H-2pcs 2+2pcs
Wedge for
tool
well/Holzkeil
/Klín koryta
Ø 19 mm
Attention/Achtung/Pozor:
Assembly Instructions, Montageanleitung, Montážní návod, Instructions de montage
PRO-AS1600
2pcs
ENG
Workbench is made of high quality beech wood guaranteeing maximum resistance and long service life of the bench.
Like all solid wood products it must not be left in areas of high humidity or damp that will cause natural movement.
Recommended humidity level max. 60%.
If you bought workbench without surface treatment, we recommend you to finish the bench by colourless varnish or oil including the bottom of workbench.
Please treat your bench with a varnish or oil within 1 months of assembly. Varnish (oil) prevents absorption of surrounding moisture. Don t forget to
repeat surface treatment each year.
To increase the rigidity of your workbench ensure that you glue the joints (please read Hint and 2) and bolt the bench in possiton .
WWoooodd iiss aanndd nnaattuurraall pprroodduucctt,, cchheecckk aanndd ttiigghhtteenn aallll ssccrreewwss aanndd bboollttss eevveerryy 66 mmoonnhhttss..
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz

!!! HINT 1 !!! - Don´t fill up holes for dowels by glue. Smear dowels by glue and instert them into holes.
ENG: These parts are already mounted on the
bottom of the workbench top. Please continue in
assembly without these parts.
X = holes for stretchers if cupboard is used !!!!
Ramia s.r.o., Zátaví 58, CZ-397 0 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz

!!! HINT 1 !!! - don´t fill up holes for dowels by glue. Smear dowels by glue and instert them into holes.
Important! Wedges for tool well are supplied separately (part H). Producer recommends to add wedges after approx. 4 weeks. Workbench
needs to adapt to the surrounding conditions. In case of need adjust the size of wedges by size of tool well.
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz