ramia PRO-AS User manual

A1-26pcs A2-8pcs B1-4pcs B2-4pcs B3-2pcs B4-3pcs C-4pcs D1-4pcs D2-4pcs E-4pcs F-1pcs G-1pcs
10x40 mm 8X40mm 5x100mm 5x90mm 4x40mm 6x40mm M12x100 M12 M12 M12
H-2pcs 2+2pcs
Wedge for
tool well
Ø 19 mm
Attention:
Assembly Instruction - PRO-AS
Workbench is made from high quality beech wood guaranteeing maximum resistance and long service life
of the bench.
NOTICE
•
The bench must not be left in damp or humid conditions which will cause movement in the wood.
Parts Packing 1 Packing 2 Date
•
The bench must not be left in damp or humid conditions which will cause movement in the wood.
Recommended humidity level max. 60%.
•If you bought workbench without surface treatment, we recommend you to finish the bench by colourless
varnish or oil including the bottom of workbench. Varnish (oil) prevents absorption of surrounding moisture.
Don´t forget to repeat surface treatment each 6 months
•To increase the stability of your workbench we recommend you to bolt the bench to the floor.
•Each months tighten all screws and bolts.
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz

1) Frame assembly
!!! HINT !!! - don´t fill up holes for dowels by glue. Smear dowels by glue and instert them into the holes.
!!! HINT !!! - don´t glue dowels for stretchers, you will not be able to use optional cupboard in future.
X = holes for stretchers if cupboard is used !!!!
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz

!!! HINT !!! - don´t fill up holes for dowels by glue. Smear dowels by glue and instert them into the holes.
3) Bench top and drawer attaching
2) Drawer assembly
Important! Wedges for tool well are supplied separately (part H). Producer recommends to add wedges after
approx. 4 weeks. Workbench needs to adapt to surrounding conditions.
In case of need adjust the size of wedges by size of tool well.
Ramia s.r.o., Zátaví 58, CZ-397 01 Písek, Czech Republic, , Tel: [phone], fax: [phone], www.ramia.cz