real living OAKMONT GB21-617 User manual

SKU# : 810499324
Use the correct screws as indicated. All screws should be hand tight untill the complete piece is assembled ( This
will make the assembly process much easier ). Once the piece is fully assembled, then go back and tight all
screws with provided tool.
OAKMONT 22IN SQ ALL WEATHER WICKER SIDE TABLE
ASSEMBLY INSTRUCTION
ITEM# : GB21-617
DO NOT RETURN THIS PRODUCT TO THE STORE. FOR MISSING PARTS OR QUESTIONS TO THIS PRODUCT PLEASE
CALL US AT 1-888-733-8169 OR EMAIL US AT
[e-mail] OR [e-mail] OR [e-mail]
IMPORTANT:
Please read all the instructions and warnings before assembling. In order to make the whole product adjust to the best, please install
all the screws on the product before fully tighten, and note to put the washer to the screw before putting the screw into the screw
hole
WARNING:
ALL WEATHER WICKER PRODUCT CARE
Before using, clean the product completely with a soft dry towel. When not in use, wipe free of any dirt or loose objects, wash with a
mild solution of soap and water, rinse thoroughly and dry completely. Do not use strong detergent or abrasive cleaners. Over time
screws can loosen. Occasinally, check screws on the table, re-tighten if necessary.
Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of the product
construction.
Keep assembly area at leat 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry line or
electrical wires.
Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be followed to
reduce the risk of personal injury and damage to the product. Please read all instructions before assembly and use.
The table is not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only.
Please be sure that all screws are securely tighten before use. Improper use of this product or failure to use as directed may result in
injury. Not intended for commercial use.
CARE & MAINTENANCE

A B C
4PC Table Leg 1PC Glass Table Top 1PC Table Tray
D E F
12PC Washer 12PC Screw(φ6x15mm) 1PC Allen Wrench
PARTS LIST
HARDWARE LIST
STEP 1
Secure 4 table legs (A) to glass table top (B) by using 8 screws (E)
and 8 washers (D) with allen wrench (F). Do not tighten all screws
now.
A
B
A
A
A

STEP 2
Secure table tray (C) to 4 table legs (A) by using 4 screws (E) and 4
washers (D) with allen wrench (F). Do not tighten all screws now.
STEP 3
Turn over the assembled table. Verify the alignment and adjust,
fully tighten all screws.
A
A
A
A
B
C